Use and Care Manual

PROBLEMS OR QUESTIONS?

Call us at 866-816-9822 or email customerservice@regencyof.com

www.regencyof.com

PG.1

Legacy Racetrack Conference Table

LCTRT7135, LCTRT9543, LCTRT12047

BEFORE YOU ASSEMBLE:

• Place all parts on a clean, smooth surface to avoid scratching the parts

• Check to be sure you have all parts & hardware

• Remove all wrapping materials, including any staples & packing straps

• Keep all hardware, small parts & packaging out of reach of children

PARTS:

E: SCREWS (x32)

G: CORNER

BRACKETS (x4)

I: CAM LOCK

COVERS (x14)

F: CAM PINS (x14)

H: FLAT

BRACKETS (x2)

J: DPEL (x1)

A:TABLE TOP (x2)

B: STRINGER (x1)

C: LEGS (x2) D: SUPPORTS (x2)

HARDWARE:

FIGURE 1: To open Cam Lock, point arrow

toward Cam Pin Hole. To close and lock

Cam, turn clockwise

PAGE 1
www.regencyof.
PAGE 2
www.regencyof.com Legacy Racetrack Conference Table LCTRT7135, LCTRT9543, LCTRT12047 STEP 1: Insert (3) Cam Pins (F) into each Leg (C). Two go on the inside, and one on the outside. STEP 2: Attach Stringer (B) to Legs (C) by lining up Cam Pins (F) with Cam Locks on Stringer (B). Secure into place and tighten Cam Locks as shown in Figure 1.
PAGE 3
www.regencyof.com Legacy Racetrack Conference Table LCTRT7135, LCTRT9543, LCTRT12047 STEP 5A: Push both Table Tops (A) together, and secure with Sash Locks—Rotate handle into the “ON” position until it locks into place. STEP 6: Using two people, move the assembled base onto the Table Tops (A), lining up each Cam Pin (F) on the Table Top (A) with a Cam Lock on the base.