Use and Care Manual

9476 • Assembly Instructions for the 9476 Side Chair

ASSEMBLY ONLY REQUIRES AT LEAST 1 PERSON & INCLUDED HARDWARE

IMPORTANT NOTICE:

• Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid scratching them.

• Check to be sure that you have all parts and hardware.

• Remove all wrapping materials, including staples & packing straps before you start to assemble.

• DO NOT tighten all screws/bolts until completely assembled.

• Keep all hardware parts out of reach of children.

Any problems or questions? Call Regency at 1-866-816-9822 or email customerservice@regencyof.com

PARTS:

HARDWARE:

F: 2x Legs

A: 2x Small Bolts

E: 1x Assembly Key

G: 1x Seat

B: 4x Large Bolts

H: 1x Seat Back

C: 4x Large Screws

*I: 2x Slats

D: 4x Bracket

*Please note that one slat is shorter than the other. Ensure that the shorter slat gets inserted into the more angled side of

the leg with holes facing inwards.

PAGE 1
9476 • Assembly Instructions for the 9476 Side Chair ASSEMBLY ONLY REQUIRES AT LEAST 1 PERSON & INCLUDED HARDWARE HARDWARE: A: 2x Small Bolts B: 4x Large Bolts C: 4x Large Screws D: 4x Bracket G: 1x Seat H: 1x Seat Back *I: 2x Slats E: 1x Assembly Key PARTS: F: 2x Legs *Please note that one slat is shorter than the other. Ensure that the shorter slat gets inserted into the more angled side of the leg with holes facing inwards.
PAGE 2
9476 • Assembly Instructions for the 9476 Side Chair ASSEMBLY ONLY REQUIRES AT LEAST 1 PERSON & INCLUDED HARDWARE STEP 1: Insert the Small Slat (I) into angled part of either Leg (F), with holes facing inwards. Ensure it is inserted all the way into the leg STEP 2: Insert the Large Slat (I) into straight beam of the same Leg (F) as STEP 1 with holes facing inwards and once again making sure it is all the way inserted.
PAGE 3
9476 • Assembly Instructions for the 9476 Side Chair ASSEMBLY ONLY REQUIRES AT LEAST 1 PERSON & INCLUDED HARDWARE STEP 7: Take note of Seat (G) orientation before placing it onto the Slats (I). There is a sticker that clarifies which side is the front of the seat. STEP 8: Once the correct orientation is found, place the Seat (G) onto the chair assembly with the front side facing away from the seat back. PLACE DOWN STEP 9: Insert Screws (C) into predrilled holes in bottom of each Slat (I) and tighten.