www.regency-fire.com Freestanding Woodstove MODELS: Tested by: 918-154b F2400M Owners & Installation Manual S2400M Installer: Please complete the details on the back cover and leave this manual with the homeowner. Homeowner: Please keep these instructions for future reference. FPI FIREPLACE PRODUCTS INTERNATIONAL LTD. 6988 Venture St.
Thank-you for purchasing a REGENCY FIREPLACE PRODUCT. The pride of workmanship that goes into each of our products will give you years of trouble-free enjoyment. Should you have any questions about your product that are not covered in this manual, please contact the REGENCY DEALER in your area. Keep those REGENCY FIRES burning. SAFETY NOTE: If this woodstove is not properly installed, a house fire may result.
TABLE OF CONTENTS THE REGENCY FREESTANDING WOOD STOVE SAFETY LABEL Glass Installation .............................................................. 17 Optional Accessories Installation Medium Freestanding Stove F2400M ................................. 4 - Pedestal Ash Drawer Kit .......................................... 17 Medium Freestanding Step Stove S2400M ........................ 5 - Bottom Shield Ashdrawer Kit ................................... 17 - Screen Door ................................
SAFETY LABEL NOTE: Regency units are constantly being improved. Check the label on the unit and if there is a difference, the label on the unit is the correct one. 244 MODEL: REGENCY MEDIUM FREESTANDING STOVE - F2400M TESTED TO: UL1482 / ULC S627 / UL 737 REPORT NO:219-S-02-2 THE F2400M MEETS UL737 STANDARD FOR FIREPLACE STOVES WHEN A FIRESCREEN IS PROVIDED. F2400M WITH AIRMATE SHIELD INSTALL AND USE ONLY IN ACCORDANCE WITH THE MANUFACTURER'S INSTALLATION AND OPERATING INSTRUCTIONS.
SAFETY LABEL NOTE: Regency units are constantly being improved. Check the label on the unit and if there is a difference, the label on the unit is the correct one. S2400M MINIMUM CLEARANCES TO COMBUSTIBLE MATERIALS BACK M FLOOR PROTECTION* K 405 mm / 16 in L 150 mm / 6 in M 150 mm / 6 in L SIDE MEASURE FLUE FROM HEATER CENTER-LINE RESIDENTIAL INSTALLATION USING SINGLE WALL CONNECTOR SIDEWALL A 406 mm / 16 in D 711 mm / 28 in BACKWALL B 280 mm / 11 in E 444 mm / 17.
UNIT DIMENSIONS 6 Regency Freestanding Woodstove
INSTALLATION RESIDENTIAL INSTALLATION 1) Please read this entire manual before you install and use your new woodstove. Failure to follow instructions may result in property damage, bodily injury or even death. Be aware that local Codes and Regulations may override some items in this manual. Check with your local inspector. 2) Select a position for your Regency Stove. Consult the minimum clearance chart for your model and set the stove in place.
INSTALLATION ROOM AIR IMPORTANT For installation using room air for combustion, remove knockout from the pedestal, and/or from the bottom if using a heat shield. Mobile home installations require the use of outside air. Note: Once the knockout is removed there are two tabs remaining. Bend both tabs out for ease of installation when attaching outside air. On pedestal units there are two locations where outside air may be adapted to the unit.
INSTALLATION Minimum Alcove Clearance to Combustible Materials The Regency Freestanding models have been alcove approved and must be installed with a listed double wall connector to the ceiling level. Note: Minimum alcove ceiling height - 84" Maximum depth of alcove - 36" Unit From From Flue Min. Min.Hearth Unit Center-line Width to Rear Wall G Medium F2400M with Airmate 15" (381 mm) with Rear Deflector 15" (381 mm) Medium S2400M Step Stove 15" (381 mm) H I J 5.5" (139 mm) 6.
INSTALLATION STOVE ASSEMBLY PRIOR TO INSTALLATION All units require either the pedestal or 4 legs attached to the base. The F2400M stove requires either the Airmate or Rear Heat Deflector on top of the stove. Clearances to combustible materials vary depending on whether the airmate or rear heat deflector is installed, so be sure to check the clearance information on pages 8 and 9.
INSTALLATION Leg and Bottom Shield Assembly F2400M & S2400M Bottom Shield 020-911 Legs (set of 4) Steel - Painted Black 850-125 Cast - Painted Black 850-126 Cast - Gold Plated 850-127 The instructions below apply to the steel leg, painted cast leg and the gold plated cast leg. It will be easier to attach the legs to the stove if the stove is tipped on its back (preferably on a soft surface to prevent scratching). Ensure to be extremely careful when tipping stove.
INSTALLATION MASONRY CHIMNEY Ensure that a masonry chimney meets the minimum standards of the National Fire Protection Association (NFPA) by having it inspected by a professional. Make sure there are no cracks, loose mortar or other signs of deterioration and blockage. Have the chimney cleaned before the stove is installed and operated. When connecting the stove through a combustible wall to a masonry chimney, special methods are needed.
INSTALLATION COMBUSTIBLE WALL CHIMNEY CONNECTOR PASS-THROUGHS Method A: 12" (304.8 mm) Clearance to Combustible Wall Member: Using a minimum thickness 3.5" (89 mm) brick and a 5/8" (15.9 mm) minimum wall thickness clay liner, construct a wall pass-through. The clay liner must conform to ASTM C315 (Standard Specification for Clay Fire Linings) or its equivalent. Keep a minimum of 12" (304.8 mm) of brick masonry between the clay liner and wall combustibles.
INSTALLATION RECOMMENDED HEIGHTS FOR WOODSTOVE FLUE Simple rules on draft. See Table 1. 3) Add 4% overall for each 1000' above sea level. 1) At sea level minimum height is 12' straight. 2) Add the following vertical height to compensate for: 45 deg. elbow = 1 ft. 90 deg. elbow = 2 ft. "T" = 3 ft. Each foot of horizontal run = 2 ft. Example: a) 1-1/2 ft. of horizontal run one "T" Total Addition (at sea level) = 3 ft. = 3 ft. = 6 ft. Example: b) One 90 deg. elbow 2 ft.
INSTALLATION MOBILE HOME INSTALLATION Once you have properly marked the position of your unit and the floor protection as outlined in the Residential Installation items #1 through #8, a supply of fresh air has to be supplied to your unit. Cut a minimum 4 inch diameter hole through your floor protector and the floor directly under your pedestal base to the outside. Use 4" duct pipe with a mesh grill to pipe fresh air into the pedestal area.
INSTALLATION LISTED COMPONENTS FOR MOBILE HOME INSTALLATION The Regency F2400M and S2400M Freestanding pedestal units are approved for installation in a Mobile Home if one of the following pipe systems is used. U.S. Installation* METALBESTOS SSII Qty. Part # Description 1 6DS-VK Connector Kit 1 6TMH Shield/Support 1 6TAF-6 Flashing 1 6T-36 Chimney Length 1 6T-18 Chimney Length 1 6T-CT Rain Cap PRO-JET 3103 Qty.Part # 1 PV06-TK 1 CSB 1 RRS 1 LFR03 1 SL3 1 SL1 1 RCSA ICC EXCEL 2100 Qty.
INSTALLATION BRICK INSTALLATION Firebrick is included to extend the life of your stove and radiate heat more evenly. Check to see that all firebricks are in their correct positions and have not become misaligned during shipping. The "AD" brick in the drawings above is the brick covering the Ash Dump hole that is used when the Ash Drawer Kit is installed.
INSTALLATION Blower/Fan (846-515) 1) Remove the two screws from the top of the fan housing. 2) Slide the fan up into the rear heat shield. 3) After aligning holes, secure the fan to the rear heat shield using the two screws removed earlier. CAUTION: The connection cord should not be in contact with any hot surfaces. Do not route cord under or in front of unit. Read the operating instructions for the fan before using. See Page 19.
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS With your unit now correctly installed and safety inspected by your local authority, you are now ready to start a fire. Before establishing your first fire, it is important that you fully understand the operation of your draft control. WARNING Fireplace Stoves equipped with doors should be operated only with doors fully open or doors fully closed.
OPERATING INSTRUCTIONS FAN OPERATION Automatic To operate the fan automatically, push the bottom switch on the side of the fan housing to "AUTO" and the top switch to either "HIGH" or "LOW" for fan speed. This will allow the fan to turn on as the stove has come up to operating temperature. It will also shut the fan system off after the fire has gone out and the unit cooled to below a useful heat output range.
MAINTENANCE MAINTENANCE It is very important to carefully maintain your fireplace stove, including burning seasoned wood and maintaining a clean stove and chimney system. Have the chimney cleaned before the burning season and as necessary during the season, as creosote deposits may build up rapidly. Moving parts of your stove require no lubrication.
PARTS LIST F2400M STOVE MAIN ASSEMBLY Part # 1) 3) 4) 5) 6) 7) 9) 12) 13) 14) 15) 16) 17) 19) 20) 22 Description 846-913 846-915 Door Assy-Med Gold F2400M (no glass) Door Assy-Med Black F2400M (no glass) 846-302 936-243 820-184 * 948-170/P 846-973 820-375 * 820-376 * 846-570 846-918 948-101 948-102 Glass - Replacement - F2400M 7/8" Adhesive Tape Gasket Glass Retainer Clips (8/set) Screw - 1/4 - 20 x 3/8" Small Glass Retainer F2400M Door Handle Assembly Ash Hole Cover Plate Bolt 1/4 - 20 x 1/2 Hex Hea
PARTS LIST S2400M STEP STOVE MAIN ASSEMBLY Part # 1) 3) 4) 5) 6) 7) 9) 16) 17) 19) 20) 846-913 846-915 846-302 936-243 846-920 * 948-170/P 846-973 846-570 846-918 948-101 948-102 Description Door Assy- Medium Gold S2400M (no glass) Door Assy-Medium Black S2400M (no glass) Glass - Replacement - S2400M 7/8" Adhesive Tape Gasket Glass Retainer Clips (8/set) Screw - 1/4 - 20 x 3/8" Small Glass Retainer - S2400M Door Handle Assembly 7/8" Door Gasket Repair Kit Hinge Caps - Gold (2/set) Spring Handle - Large Sp
PARTS LIST PEDESTAL, BOTTOM SHIELD & LEG OPTIONS Part # Description 48) 49) 50) 020-915 904-257 * Pedestal - Medium Large Magnet Catch Blanking Plate - Pedestal 45) 46) 58) 59) 850-100 * * 942-110 820-249 Ashdrawer Kit - Pedestal Ashdrawer - Pedestal Ashdrawer Lid Assy Ash Plug Ash Plug Tool Handle 56) 57) 020-911 * Bottom Shield - Medium Blanking Plate - Btm Shield 55) 58) 59) 850-101 * 942-110 820-249 Ashdrawer Kit - Btm Shield Ashdrawer - Bottom Shield Ash Plug Ash Plug Tool Handle 140) 850
PARTS LIST FIREBRICK Part # 70) 74) 75) 76) 902-111 802-147 802-122 802-152 Description Brick Brick Brick Brick - Regular Full Size: 1-1/4" x 4-1/2" x 9" Partial: 1-1/4" x 4-1/2" x 3-1/2" Partial: 1-1/4" x 4-1/2" x 2" Partial: 1-1/4" x 2" x 9" Regency Freestanding Woodstove 25
NOTES _____________________________________________________________________________________ ____________________________________________________________ __________________________________________________________ ____________________________________________________________ _______________________________________________________ _____________________________________________________ __________________________________________________________ _________________________________________________________ ____________
WARRANTY Regency Fireplace Products are designed with reliability and simplicity in mind. In addition, our internal Quality Assurance Team carefully inspects each unit thoroughly before it leaves our door. Regency Industries Ltd. is pleased to extend this limited lifetime warranty to the original purchaser of a Regency Product. This warranty is not transferable.
Regency fireplace products are designed with reliability and simplicity in mind. In addition, our internal Quality Assurance Team carefully inspects each unit thoroughly before it leaves our door. Fireplace Products International Ltd. is pleased to extend this Limited Lifetime Warranty to the original purchaser of a Regency Product. See the inside back cover for details. Register your Regency online at http://www.regency-fire.