USER MANUAL
RB3000 precision tonearm Rega is renowned for the quality of its tonearm bearing assemblies. In particular the accurate manufacturing of our bearing housing and bearing spindles. Technical characteristics such as “roundness” and “parallelity” (the condition of being parallel) are critical. Over the past three years Rega has found a new manufacturing process which improves on all these characteristics resulting in a micron perfect bearing fit.
Balance weight Tracking force dial Cueing platform Cueing device lift/lower handle Arm clip (1:4 scale) Protractor and arm mounting data included.
Fitting your tonearm The RB3000 will directly replace any other Rega tonearm that currently uses the 3 point mounting, without any modification. If fitting to another manufacturers product or an older Rega turntable (with the single point nut fixing), the supplied template should be used as a guide to ensure correct position and alignment. With so many variants in turntable models, it is important to contact your turntable manufacturer if in any doubt before making any holes in plinths or arm boards.