LED Floodlight QUICK START GUIDE
Assembly Guide Wire Nuts Bracket Screws Mounting Bracket Junction Box (not included) Gasket
Mounting Base Bracket Screw
What’s Included Floodlight Gasket Mounting Bracket Screwdriver Wire Nuts (x3) Long Bracket Screw Medium & Short Bracket Screws (x2 each) Note:
Before You Begin Shut OFF the power at the fuse or circuit breaker box. DO NOT rely on a wall switch alone to turn off the power. If you’re unsure which switch it is to turn off the floodlight power, please consult with a licensed electrician. Make sure your setup location will have strong Wi-Fi reception. This equipment is intended for installation in a restricted access location.
Step 1: Download the app Reflection Home Download the Reflection Home App from the Apple App Store or Google Play. Connect your mobile device Wi-Fi to the network you want your camera to be paired to. The app also includes the installation instructions and videos if you prefer. Important: Make sure the app you download matches the same logo as shown above.
Step 2: Remove your existing floodlight Use a screwdriver or another tool to remove your existing floodlight from the junction box. Disconnect the three sets of wires from the floodlight. If there is a mounting bracket attached to your junction box, you may remove that as well.
Step 3: Install the bracket and gasket Use the provided screws in the box to install the mounting bracket onto your junction box. Make sure it is tight and secure. With the provided gasket, peel off the white tape and stick that side around the opening in the wall. Make sure the center hole lines up with the center bracket hole and that there are no openings around the gasket.
Step 4: Connect the wires You should see three sets of wires from both your wall and the mounting base: a ground wire (usually green or copper), black wire, and white wire. Use the provided wire nuts to twist the open ends of the matching wires together.
First, make sure that the mounting base is set properly. With the provided long screw, push the screw through the middle screw-hole of the mounting base. Use the provided screwdriver to tightly secure it. Ensure that the gasket and base is tight and does not move.
The floodlight can now be mounted onto the mounting base. Make sure the screwhole at the top matches on both the mounting plate and the floodlight, then use the provided screw and screwdriver to screw them tightly in place.
Turn on the power from the power breaker. Once the power is back on, a sound will play from the floodlight notifying you that it’s ready to pair. Go back into the Reflection Home app and follow the in-app screens to complete the pairing process.
Reset 1. To perform a factory reset, you must open the cap and hold its internal reset button for 10 seconds.
Light Indicators & Status 1. 2. 3. 4. Solid Pink – Booting Blinking Red – Recording in progress Blinking Blue – Ready to connect to WiFi Double Blinking Blue – Connecting to Wi-Fi 5.
FCC Warning This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
• Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. Reflection International Inc.
www.reflectionamerica.