Assembly Instructions

Redpoint Positioning, Corp.
100 N Washington Street
6
th
Floor
Boston, MA 02114, USA
Date (2020-11-25)
Federal Communications Commission
Equipment Authorization Branch
7435 Oakland Mills Road
Columbia, MD 21046
Modular Approval Request
FCC ID: 2ADX4-MDEV7
The following attestation addresses the requirements to support modular approval:
Modular approval requirement Yes (provide brief statement) No *
(a) The radio elements must have the
radio frequency circuitry shielded.
Physical components and tuning
capacitor(s) may be located external
to the shield, but must be on the
module assembl
y
Yes
(b) The module must have buffered
modulation/data inputs to ensure that
the device will comply with Part 15
requirements with any type of input
signal
Yes
(c) The module must contain power
supply regulation on the module
Yes
(d) The module must contain a
permanently attached antenna, or
contain a unique antenna connector,
and be marketed and operated only
with specific antenna(s), per Sections
15.203, 15.204(b), 15.204(c),
15.212(a), 2.929
(b)
Yes, the module has a unique
antenna connector, and is
marketed and operated only with
specific antenna(s).
(e) The module must demonstrate
compliance in a stand-alone
configuration
Yes
(f) The module must be labelled with
its permanently affixed FCC ID label,
or use an electronic display (See
KDB Publication 784748 about
labelling requirements)
Yes, FCC ID is printed on the
physical label of the module.
(g) The module must comply with all
specific rules applicable to the
transmitter. The grantee must provide
comprehensive instructions to explain
compliance requirements
Yes