WATERPROOF BLUETOOTH CONTROLLER RB1 Recoil IPX7 Waterproof Bluetooth Controller User Manual RB1
WATERPROOF BLUETOOTH CONTROLLER RB1 Introduction Thank you for choosing Recoil Bluetooth remote controller. We invested a lot of time and effort planning and designing the perfect controller for your audio system. If at any given time you have any questions or concerns, please feel free to contact us at: support@recoilaudio.com Enjoy your ride! RB1 wires and plugs diagram Amplifier-Controller DIN plug Remote In Aux input Amplifier-Controller DIN plug The RB1 controller has a DIN plug.
WATERPROOF BLUETOOTH CONTROLLER RB1 Introduction Remote In - Blue Wire (Should not be used) The remote-in is an extra feature we added to the RB1. You should NOT use this wire unless your RB1 controller is hooked up to another source unit. So, when that source unit is turned on/off, RB1 will be turned on/off also automatically.
WATERPROOF BLUETOOTH CONTROLLER RB1 Setup Pairing Bluetooth® Device Go to settings on your phone and place Bluetooth® setting into " discoverable" mode. Search for (RB1)device. On phone select (RB1) to pair device. Once a device is paired each time this device is seen by the Recoil RB1, it will automatically reconnect to the device. If no device is present the Recoil RB1 automatically goes into pairing mode and will present itself as discoverable for the next device present.
WATERPROOF BLUETOOTH CONTROLLER RB1 The Volume Up/Volume Down buttons will control the volume level of your Tunes, best practice: set your audio source's Volume at around 85% (on your phone, MP3 player etc) and control the volume using the RB1 controller. Bluetooth trouble Shooting Guide Make sure volume is up on Bluetooth sources Confirm Pairing if no sound. Mounting The RB1 controller has 2 mounting options: 1. Dash or Flush (Rear) mount 2.
WATERPROOF BLUETOOTH CONTROLLER RB1 Mounting Surface mount: This method will allow you to mount the RB1 on any perfectly flat surface. Using this method will not require any cutting or drilling of the surface. STEP 1: Place the RB1 cables in the rail found on the inner side of the surface mount plate, and screw the plate to the back of the RB1, using the 2 M4 cross head screw. Then stick the 3M Sticker on the back of the surface mount plate.