User Manual

INDUSTRIAL ZONE, NINGBO 315800, CHINA
ICLED-4C
1. Main control module
2. 4-LED output connectors
3. 3ft Power/Ground/Remote turn on wire
Recoil' s digital LED controller uses advanced PWM (Pulse Width Modulation) digital
control technology for precise and accurate color management. The controller can
only be operated using the EZLED PRO phone app. This app is available in both
and
The ICLED-4C can operate at 12V DC - Ensure you are using digital RGB LED whip lights,
or speakers with digital LEDs which matches the output voltage to the controller.
1. Connect the +12V, GND (ground) and REM into your contoller. Use 24 guage wire
and connect the REM wire to an optional SP /ST switch (not included with the controller)
or lgnition, or some switched 12V DC output wire ! to turn-on and turn-off the digial LED
controller and all LEDs.
2. Now connect your digital whip lighters to the 4 output connectors.
DIGITAL RGB LED CONTROL MANUAL
ICLED-4C Manual
Introduction
Connecting ontoller
At Setting, turn on Shake to the
left to change Color randomly.
Turn on Shake to the right to
change Mode randomly.
SETTING SCREEN
Hit the left top menu button to
connect your controllers.
Setting is here also at the right
top. At bottom is the user
interface page change.
MAIN STARTUP
Hit the right top menu button to
enter Setting. Select RGB LED
Chip firstly, Then enter the
quantity of LED for each
output. Tap the green box to
enter the number.
SETTING SCREEN