Quick Start Guide

ManualsBrandsReaXium ManualsComputers & AccessoriesReaXium Tablet PC

Table Of Contents



Enterprise tablet

Quick Start Guide

Appearance and Buttons

Front Camera

Touch Screen

Package Contents

Devicex 1Batteryx 1Power adapterx 1USB cable x 1

Quick Start Guide & Warranty Policy x 1

Unpacking Instructions

SIMCard,TFCardInstallationMethod

Note:SIM card 1, 2 are Nano SIM cards.

Use the silver tab on the top left corner to pull out the SIM card/TF

card holder. Place the SIM card、PSAM card and TF card into the

respective slots (as shown). Push the holder in completely:

Battery Installation

1 Install the battery in the direction as show.

2 Place the back cover fully, then, push the lock buckle to the lock.

NOTE: Overexertion should be avoid when installing or removing

the battery.

System LED

Scanner LED

NFC

Scan Button

P1-P8

Custom Button

Metal

Wrist Buckle

Battery

Cover Locker

POGO PIN

Rear Camera

Flash

Volume

Up+/Down-

Power Button

USB/

Charging

Port

Earphone

Port

Scan Engine

POGO PIN

Loudsperker

TF Slot

Nano SIM Slot 1 Nano SIM Slot 2

PSAM

Card Tray

Battery Locker

Battery Cover Locker

3.01.200.10035

Summary of content (3 pages)

PAGE 1
Package Contents Appearance and Buttons Device x 1 Battery x 1 Power adapter x 1 USB cable x 1 Quick Start Guide & Warranty Policy x 1 System LED Front Camera NFC Scanner LED Unpacking Instructions Scan Button P5 Touch Screen P6 P3 P7 P4 P8 P1-P8 Custom Button SIM Card, TF Card Installation Method Use the silver tab on the top left corner to pull out the SIM card/TF PSAM Nano SIM Slot 1 Rear Camera P5 P6 P3 P7 P4 P8 PSAM card holder.
PAGE 2
Power Options Power on: Press and hold the power button until device vibrates. Shutdown: Press and hold the power button until the shutdown prompt appears Click“Shutdown”. Forced restart: Press and hold the power button for 10 seconds. Do not press the shutdown prompt. Device will restart. Note: 1.When the device as a SLAVE connect to PC, ' This device ' option will be automatically selected. 2.When the device as a HOST connect to other devices,'Connected device' will be automatically selected.
PAGE 3
Declaration Warning This device(FCC ID: ) complies with part 15 of the FCC rules. Operation is subject to the following two conditions:(1) the device may not cause harmful interference, and (2) this device must accept any interference received,including interference that may mause undesied operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.