RTL8852AE User’s Manual (Realtek RTL8852AE) 11ax RTL8852AE Combo module Module User’s Manual Realtek Semiconductor Corp. No. 2, Innovation Road II, Hsinchu Science Park, Hsinchu 300, Taiwan Tel.: +886-3-578-0211. Fax: +886-3-577-6047 www.realtek.
RTL8852AE User’s Manual CONTENT ENVIRONMENTAL .......................................................................................................................... 3 WARNING .......................................................................................................................................... 4 Federal Communication Commission Interference Statement ...................... 4 INDUSTRY CANADA STATEMENT ....................................................................................
RTL8852AE User’s Manual ENVIRONMENTAL Parameter Minimum Maximum Units -55 +125 C Ambient Operating Temperature 0 70 C Junction Temperature 0 125 C Storage Temperature
RTL8852AE User’s Manual Warning Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
RTL8852AE User’s Manual This device meets all the other requirements specified in Part 15E, Section 15.407 of the FCC Rules. Radiation Exposure Statement: (Mobile) This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This module is intended for OEM integrators only.
RTL8852AE User’s Manual 2.7 Antennas The following antennas have been certified for use with this module; antennas of the same type with equal or lower gain may also be used with this module. The antenna must be installed such that 20 cm can be maintained between the antenna and users. Approved antenna(s) list :(Mobile) Antenna Set Antenna Frequency Chain NO.
RTL8852AE User’s Manual end-product for any additional compliance requirements required with this module installed. IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop configurations or co-location with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID can not be used on the final product.
RTL8852AE User’s Manual accepter tout brouillage reçu, y compris un brouillage susceptible de provoquer un fonctionnement indésirable. Radiation Exposure Statement: (Mobile) This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with greater than 20cm between the radiator & your body.
RTL8852AE User’s Manual This device is intended only for OEM integrators under the following conditions: (For module device use) 1) The antenna must be installed and operated with greater than 20cm between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna. As long as 2 conditions above are met, further transmitter test will not be required.
RTL8852AE User’s Manual End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed and operated with greater than 20cm between the antenna and users. The final end product must be labeled in a visible area with the following: “Contains IC: 6317A-RTL8852AE”.
RTL8852AE User’s Manual final quant à la façon d'installer ou de supprimer ce module RF dans le manuel de l'utilisateur du produit final qui intègre ce module. Le manuel de l'utilisateur final doit inclure toutes les informations réglementaires requises et avertissements comme indiqué dans ce manuel.
RTL8852AE User’s Manual modèle de l’antenne et les pires angles d’inclinaison nécessaires pour rester conforme à l’exigence de la p.i.r.e. applicable au masque d’élévation, énoncée à la section 6.2.2.3, doivent être clairement indiqués DETACHABLE ANTENNA USAGE This radio transmitter (IC: 6317A-RTL8852AE / Model: RTL8852AE) has been approved by ISED to operate with the antenna type listed below with maximum permissible gain indicated.
RTL8852AE User’s Manual 低功率電波輻射性電機管理辦法 取得審驗證明之低功率射頻器材,非經核准,公司、商號或使 用者均不得擅自變更頻率、加大功率或變更原設計之特性及功能。 低功率射頻器材之使用不得影響飛航安全及干擾合法通信;經發現有干擾現象 時,應立即停用,並改善至無干擾時方得繼續使用。前述合法通信,指依電信管 理法規定作業之無線電通信。低功率射頻器材須忍受合法通信或工業、科學及醫 療用電波輻射性電機設備之干擾。 1. 使用此產品時應避免影響附近雷達系統之操作。 2. 高增益指向性天線只得應用於固定式點對點系統。 模組認證: 1. 本模組於取得認證後將依規定於模組本體標示審驗合格標籤。 2. 系統廠商應於平台上標示「本產品內含射頻模組: XXXyyyLPDzzzz-x」字樣。 Japan Statement Host system must be labeled with "Contains MIC ID:xxxxxx“, MIC ID displayed on label.
RTL8852AE User’s Manual Installing PCIe NGFF2230 module to PCIe NGFF2230 connector and connect two external Wi-Fi antennas on I-PEX connectors.
RTL8852AE User’s Manual Installing the WLAN PCIe & Bluetooth USB NGFF2230 module Software Before you proceed with the installation, please notice following descriptions. Note1: The following installation was operated under Windows 7. Note2: If you have installed the WLAN driver & utility before, please uninstall the old version first. A. Execute the “setup.
RTL8852AE User’s Manual B. Select ”I accept the terms in license agreement” and click “Next” to process the installation C. Click “Next” button.
RTL8852AE User’s Manual D. Select “Complete” and click “Next” button.
RTL8852AE User’s Manual E. Click “Install” button. F. Click “Finish” button.
RTL8852AE User’s Manual G. Please click “Next”to continue. H. Please click “Next”to continue.
RTL8852AE User’s Manual I. Please click “Install”to start installation. J. Please click “finish”to finish the installation.
Un-installing the Wireless PCIe NGFF2230 module Software A. Uninstall the RTL8852AE WLAN Driver from “Start”→ “Control Panel”→ “Programs” Please select items as below and click “Uninstall” to remove RTL8852AE WLAN, BT driver and MP UI.