RTL8191SE-GR SINGLE-CHIP IEEE 802.11b/g/n WLAN CONTROLLER with PCI EXPRESSTM INTERFACE DATASHEET Rev. 0.4 26 Nov 2008 Track ID: JATR th Realtek Semiconductor Corp. No. 2, Innovation Road II, Hsinchu Science Park, Hsinchu 300, Taiwan Tel.: +886-3-578-0211. Fax: +886-3-577-6047 www.realtek.com.
RTL8191SE-GR Datasheet COPYRIGHT ©2008 Realtek Semiconductor Corp. All rights reserved. No part of this document may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form or by any means without the written permission of Realtek Semiconductor Corp. DISCLAIMER Realtek provides this document “as is”, without warranty of any kind, neither expressed nor implied, including, but not limited to, the particular purpose.
RTL8191SE-GR Datasheet Table of Contents 1. GENERAL DESCRIPTION................................................................................................................................................4 2. GENERAL FEATURES ......................................................................................................................................................5 3. APPLICATION DIAGRAM ......................................................................................................
RTL8191E-GR Datasheet 1. General Description The Realtek RTL8191SE is a highly integrated single-chip MIMO wireless LAN (WLAN) solution for the wireless high throughput 802.11n draft specification. It combines a MAC, a 1T2R capable baseband, and RF in a single chip. The RTL8191SE provides complete solution for a high throughput performance wireless client.
RTL8191E-GR Datasheet 2. General Features General 64-pin QFN CMOS MAC, Baseband MIMO PHY, and RF Single Chip for IEEE 802.11b/g/n compatible WLAN Complete 802.11n MIMO solution for 2.4GHz band 1x2 MIMO technology for extended reception robustness and exceptional throughput Maximum Tx/Rx PHY data rate up to 75M/150Mbps using 20Mhz bandwidth, 150M/300Mbps using 40Mhz bandwidth Compatible with 802.11n draft 2.0 specification Backward compatible with 802.11b/g devices while operating at 802.
RTL8191E-GR Datasheet - 4-wire EEPROM control interface (93C46) Configurable LED pins (2) Configurable Bluetooth Coexistence Interface PHY Features IEEE 802.11n draft 2.0 MIMO OFDM - 1 transmit and 2 receive paths (1T2R). - 20MHz and 40MHz bandwidth transmission. - Short Guard Interval (400ns). DSSS with DBPSK and DQPSK, CCK modulations with long and short preamble. OFDM with BPSK, QPSK, 16QAM, and 64QAM modulations. Convolutional coding rate: 1/2, 2/3, 3/4, and 5/6. Maximum data rate 54Mbps in 802.
RTL8191E-GR Datasheet 3. Application Diagram 3.1. Single band 11n application You can use RTL8191SE (11n 1x2 MAC/BB/RF) to support the flexible single band MIMO (1x1/1x2) solution upon your various requirement. RX I/Q AntennaA TX I/Q Figure 1. Single Band 11n Application Diagram Wireless LAN Network Interface Controller 7 Rev.0.
RTL8191E-GR Datasheet 4. Pin Assignments 48 47 46 45 44 43 42 41 40 39 38 37 36 35 34 33 49 32 BT_PRI 50 31 BT_STATE VD33A 51 30 WL_RX NC 52 29 WLACT NC 53 28 GND NC 54 27 NC VD33D 55 26 XO GPIO4 56 25 XI GPIO5 57 24 VD15A VD12D 58 23 VD18A GND 59 22 RETX EEDO 60 21 VD33A EEDI 61 20 LED1 EESK 62 19 LED0 EECS 63 18 ANT_SEL_N TSSI_0 64 17 10 11 12 13 14 15 16 ANT_SEL_P GND LX RTL8191SE 65 GND (Exposed Pad) 1 2 3 4 5 6 7 8 9 Figure 2.
RTL8191E-GR Datasheet 5. Pin Descriptions In order to reduce pin count, and therefore size and cost, some pins have multiple functions. In such cases, the functions are separated with a ‘/’ symbol. Refer to the Pin Assignments diagram on page 10 for a graphical representation. The following signal type codes are used in the tables: I: Input. O: Output T/S: Tri-State bi-directional input/output pin. S/T/S: Sustained Tri-State. O/D: Open Drain. P: Power pin. 5.1. PCIE Transceiver Interface Table 1.
RTL8191E-GR Datasheet 5.3. Power Pins Table 3. Power Pins Symbol LX GND VD33A VD12D VD18A VD15A VD33D VD18D VD12A RETX Type P P P P P P P P P P Pin No 50 28,41,59 3,11,21,39,51 36, 58 7,15,23 24 55 37 40 22 Description Input VDD33 Regulator GND VDD 3.3V for Analog. +1.2V (Digital) VDD 1.8V for Analog. Analog 1.5V Capacitor VDD3.3V for Digital VDD 1.8V for Digital. VDD 1.2V for Analog For Bandgap and Bias 5.4. RF Interface Table 4.
RTL8191E-GR Datasheet 5.6. Clock and Other Pins Table 6. Clock and Other Pins Symbol XI Type I Pin No 25 XO ISOLATIONn O I 26 48 VAUXEN/EESK I 62 GPIO0/WLAN_ ACT I/O 29 GPIO1/WLAN_R X GPIO2/BT_STAT E GPIO3/BT_PRI I/O 30 I/O 31 I/O 32 GPIO4 GPIO5 GPIO6/EEDO GPIO7/EEDI I/O I/O I/O I/O 56 57 60 61 Description 40MHz OSC Input. Input of 40MHz Crystal clock reference. Output of 40MHz Crystal clock reference. This pin can externally shutdown 8191SE without extra power switch.
RTL8191E-GR Datasheet Symbol DVDD18 DVDD12 Parameter 1.8V Supply Voltage 1.2V Core Supply Voltage Wireless LAN Network Interface Controller Conditions 12 Minimum 1.71 1.10 Typical 1.8 1.2 Maximum 1.89 1.32 Units V V Rev.0.
RTL8191E-GR Datasheet 7. Mechanical Dimensions Symbol Min 0.75 0.00 0.55 Dimension in mm Nom 0.85 0.02 0.65 0.20 REF 0.25 9.00BSC 8.75BSC 5.5 0.50BSC 0.40 — — — — — — — Max 1.00 0.05 0.80 A A1 A2 A3 b 0.18 0.30 D/E D1/E1 D2/E2 5.25 5.75 e L 0.30 0.50 θ 0o 14o aaa — 0.15 bbb — 0.10 ccc — 0.10 ddd — 0.05 eee — 0.08 fff — 0.10 Notes： 1. DIMENSIONS D1 AND E1 DO NOT INCLUDE MOLD PROTRUSION. 2. CONTROLLING DIMENSION：MILLIMETER(mm). 3. REFERENCE DOCUMENTL：JEDEC MO-220.
RTL8191E-GR Datasheet 8. Ordering Information Table 8. Ordering Information Part Number RTL8191SE-GR Package QFN-64, Green package Status Enineering Sample (Blank) Realtek Semiconductor Corp. Headquarters No. 2, Innovation Road II, Hsinchu Science Park, Hsinchu, 300, Taiwan, R.O.C. Tel: 886-3-5780211 Fax: 886-3-5776047 www.realtek.com.tw Wireless LAN Network Interface Controller 14 Rev.0.
RTL8191E-GR Datasheet FCC Statement Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
RTL8191E-GR Datasheet LABEL OF THE END PRODUCT: The final end product must be labeled in a visible area with the following " Contains TX FCC ID: TX2-RTL8191SE ". IC Statement Country Code Statement For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is not possible. This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.
