Installation Instructions

ManualsBrandsReality Interactive ManualsComputers & Accessories8 inch tablet

Kit Contains:

• 1 Thermo-Scanner

• 1 Power Supply

• 2 Allen Wrenches

1. Open the box and remove the Thermo-Scanner.

2. Take the power supply out of the box. Connect the power cable to the power brick.

3. Take the larger of the two hex key wrenches out.

4. Use the hex key wrench to unscrew the two screws shown in the photo below (there will

be one screw on each side). Larger wrench loosens the arm to position it to be placed in

the electrical box. The smaller wrench tightens the mounting arm.

5. Rotate the mounting bracket as shown in the photo below. Screw the two hex screws

back in.

6. The device should now look like the photo below once the mounting bracket has been

rotated.

7. Install the Thermo-Scanner on to the desired mount (i.e., wall, free-standing, table-top,

junction box). The diameter of the mounting hole is 1.299 inches (33mm).

a. If using a junction box, follow the steps below. It will fit in a 1.25 inch electrical

knock out.

b. A 4"H x 4"W x 4"D enclosure with knockouts will be needed.

c. Punch out a hole on the top of the box.

Model: Face ID X8 V2

FCC ID: 2AWPHFEX8V2

Instructions:

Summary of content (4 pages)

PAGE 1
Kit Contains: • • • 1. 2. 3. 4. Model: Face ID X8 V2 FCC ID: 2AWPHFEX8V2 Instructions: 1 Thermo-Scanner 1 Power Supply 2 Allen Wrenches Open the box and remove the Thermo-Scanner. Take the power supply out of the box. Connect the power cable to the power brick. Take the larger of the two hex key wrenches out. Use the hex key wrench to unscrew the two screws shown in the photo below (there will be one screw on each side). Larger wrench loosens the arm to position it to be placed in the electrical box.
PAGE 2
d. Unscrew the small black ring piece on the thread of the Thermo-Scanner's mounting bracket. e. Run the cables through the hole in the junction box. f. Screw the black ring piece back on to the thread of the mounting bracket to secure the scanner to the box. 8. Ensure the bottom of the Thermo-Scanner is 5 feet from the floor. 9. Install the Thermo-Scanner mounting bracket perpendicular (90 degrees) to the floor (not on any other angle). 10.
PAGE 3
Please use the product according to the following safety instructions and warnings: * Do not place the camera in extremely hot, cold, dusty or damp location. * Do not expose it to high electromagnetic radiation. * If the product does not work properly, please contact 860-600-0336. * Never attempt to disassemble the camera yourself. (We shall not be responsible for any problems caused by unauthorized repair or maintenance.) * Do not drop the camera or subject it to physical shock.
PAGE 4
FCC compliance statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.