Rocker Dig II - Manual

RC4WD Rocker Dig unit Instructions
The RC4WD Dig unit controls the front and rear motors on a MOA (motor
on axle) setup. This allows you to control the power to the motor with your
third channel of your radio.
Requirements:
MOA crawler.
Radio with at least 3 channels. The third channel must have a three position
switch.
Mounting Position:
This dig unit can be mounted anywhere on the truck. Near the ESC is going
to be the best spot as the lead wires will need to reach the ESC.
Power Connections:
There are two short wires, Red and Black coming from the Dig control box.
These get connected to you Red and Black motor wires from your ESC.
There are 4 long motor wires coming from the dig unit. 2 Red, 2 Black. Take
these and hook one red and one black to each motor.
Receiver Connection:
Connect the receiver plug into your third channel slot of your radios
receiver.