Installation Manual Part 4

ManualsBrandsRaytheon IIS ManualsElectronicsAir-Ground Radio System

FCC ill: CDG-ARTU

MAGNASTAR

EXHIBIT C

C-2000 DIGITAL AIRBORNE TELEPHONE SYSTEM

7.1.2.5.4 SATCOM Terminal ro's

The following screen progressions show how to enter a terminal 10 number for SATCOM ground to air calling. The

procedure to enter a station or aircraft terminal 10 number are the same. A station terminal 10 number applies, or will ring,

only the associated handset being programmed. An aircraft terminal 10 number applies, or will ring, all the handsets in the

system. The screen progression also shows how to cancel a terminal 10 number. An aircraft terminal 10 is a system function

and need only be programmed from one handset.

Station

Terminal

Inplane > 1

Aircall >2

Satcom ->3

s.lect

-->

select

-->

001

select

station or

aircraft.

-->

Enter

terminal

ID.

To Disable

Call

Waiting >4

New:

OK >+

Clear -->*

Go Back >t

select

cancel if

required.Go Back >t

7.1.2.5.4.1 Disabling a Station From Ringing with a SA TCOM Aircraft TerminailD

It is possible to disable a number of individual handsets or active ports from ringing when an aircraft terminallD number is

programmed in the system Each handset or active port that is not to respond to an aircraft terminallD number must be

programmed as such. The following screen progressions show the steps necessary to cancel an aircraft terminallD response.

Inplane > 1

Aircall >2

Satcom ->3

select

-->

Select

-->

Select

-->

Select

Yes or

No for

aircraft

terminal

response

To Disable

Call

Waiting >4

Go Back >.

RevB

7-11

Summary of content (8 pages)

PAGE 1
FCC ill: CDG-ARTU MAGNASTAR EXHIBIT C C-2000 DIGITAL AIRBORNE TELEPHONE SYSTEM 7.1.2.5.4 SATCOM Terminal ro's The following screen progressions show how to enter a terminal 10 number for SATCOM ground to air calling. The procedure to enter a station or aircraft terminal 10 number are the same. A station terminal 10 number applies, or will ring, only the associatedhandsetbeing programmed. An aircraft terminal 10 number applies, or will ring, all the handsetsin the system.
PAGE 2
EXHIBITC FCC ill: CDG-ARTU C-2000 DIGITAL AIRBORNE TELEPHONE SYSTEM MAGNASTAR 7.1.2.5.5CaD Waiting The following screenprogressions show bow to enable or disable the call waiting feature. Call waiting will alert the user of an additional incoming call regardlessof its origin (inplane or ground initiated) while engagedin a telephone call.
PAGE 3
EXHIB IT C FCC ID: CDG-ARTU MAGNASTAR C-2000 DIGITAL AIRBORNE TELEPHONE SYSTEM configure Select 6 for AIU. --> Satcom Select 1 for SAreOM --> -->1 Impedance ~~~~~~~i Mode Handset >3 ~---~>2 SatcODl / GroundCell Select-->3 Make the appropriate selection to match the aircraft configuration The current configuration will Go Back Go Back >1 >1 be highlighted. - 7.1.2.5.
PAGE 4
FCC ill: CDG-ARTU EXHIBIT C MAGNASTAR C-2000 DIGITAL AI RBORNE TELEPHONE SYSTEM Select + to reach second maintenance from the first.
PAGE 5
EXHIBIT C FCC 10: CDG-ARTU MAGNASTAR C-2000 DIGITAL AIRBORNE T LEPHONESYSTEM 7.1.2.6.1 Station Setup A MagnaStar digital handsetwhen connectedto the LAN is considered a station. It is possible to configure a handsetfor different types of operation or station types. A Cabin station is the system default mode and is considered the normal condition. A Cockpit station is the same as a Cabin station except for operation when the system Billing mode is configured for credit card.
PAGE 6
EXHIB rr c FCC ill: CDG-ARTU MAGNASTAR C-2000 DIGITAL AIRBORNE TELEPHONE SYSTEM ~..;;;- The higher -Enable- rate feature or -Disable. may be~tQgg1ed to display by entering a keypress of 1. Warning: The Enable or Disable shown on the screen describes the state the system will be placed when 1 is pressed. This screen indicates that the higher rate PAX Aero-H+ Satcom dialing prefix is enabled. 7.1.1.6.
PAGE 7
EXHIBrrc FCC ill: CDG-ARTU MAGNASTAR C-2000 DIGITAL AIRBORNE TELEPHONE SYSTEM For MagnaStar systemsthat are interfaced to a SATCOM unit, it is possible to configure each station to use either the GTE Airfone ground network or the SATCOM satellite system as the default link. The default link is station programmable. The MagnaStar system default is the GTE Airfone system (Air to Ground).
PAGE 8
EXHlBITC FCC ID: COG-ARTU MAGNASTAR C-2000 DIGITAL AIRBORNE TELEPHONE SYSTEM ~-- Select + --> select I Enter 1 2 3 4 Select the de. ired inplane number The inplane number will then be Highlighted. No --> Go Back >1 7.1.2..6.7 MODEM Settings 4800 bps and 9600 bps MODEM call bandoffs between ground stations can be independently enabled or disabled as a system function (i.e. for the entire aircraft) from a maintenancemenu.