User's Manual

IMPORTANT: You must install the software before installing the
Bluetooth Dongle. During the software installation,you will be prompted
to install the device (For Windows 2000/XP users).
Insert the installation CD into the CD-ROM drive . The installationstarts aut-
omatically and guides you through the software installation.(If the installation
process does not start automatically, locate SETUP.exe on the instalation CD
and double click SETUP.exe to continue.)
1.The "Bluetooth Settings" screen willautomatically be displayed, click the
"Install" button.
2.Followthe installationwiz ard and complete theste psto install Bluetooth
software.
3.When theLic enseAg reement screenis displayed, readthe LicenseAg reem-
ent,then clickthe radiobut tonto theleftof "I accept theterm s in thelice nse
agreement"andclickthe "OK"Butt on.
4.Thesyst emis ready to install the Bluetooth software. If you needto review
or changethe any settings, clickthe "Back" button. Clickthe" Cancel"butt on
to exit theWiz ard. Otherwise, clickthe "Install" button.
5.During installation, system will try to detect your Bluetooth device .Plug in
your Bluetooth device securely whenthe prompted and click"OK " To continue
(For Windows 2000/XP users).
6.Theinst allationprog ram will install thedriv er forthe Bluetooth device autom-
atically. This may take several minutes. Pleasewait .
7.When theins tallationis completed, click"Yes" to restart your computer.If you
plan to restart later, click"NO ".
For more Information about the Bluetooth software configuration , please
check the User's Guide orthe ReleaseNotes onthe driver and software CD!
FEDERAL COMMUNICATIONS COMMISSION
This device complies with Part 15of theFC C Rules. Operationis
subject to thefoll owingtwocon ditions:(1) this device may not cause
harmfulinte rference, and (2) this device must accept any interference
received, includinginte rference that may cause undesiredope ration.
Installing Bluetooth Software for Windows
BTD-121 Bluetooth Class2 Dongle
NOTE
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses and can radiated radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications.However, there is no guarantee
that interference will not occur in a particular installation If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user s authority to operate
theequipment. his device and its antenna(s) must not be co-located or
operating in conjunction with any other antenna or transmitter.
Warning: Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user authority
to operate the equipment.
Service Center
Rayming Corporation
18688 San Jose Ave., City of Industry, CA 91748
Phone No.: 626-839-0366
Fax No.: 626-839-7038
Contact person: Grant Tsao
e-mail: [e-mail]