Installation Guide

Base Station & Wireless Controller Installation guide

Self-tapping

screws

Base Station

Pozidriv screwdriver

Power Drill

Parts supplied

Tools Required

inch (2.7 mm) drill

inch (3.4 mm) drill

S100 REMOTE

MODE

STANDBY

PILOT

S100 Remote Smart Controller

Lanyard

Cradles x2

3 Way

Connector

Block

SeaTalk Cable

Charging Cable

Ferrite

AAA batteries x2

STANDBY

PILOT

MODE

No. 6 size

No. 8 size

Min 3ft 3in (1m)

Locating Base Station

Fit as high up as possible, in a dry location

Fitting remote

Mark holes for the fixing screws.

Drill three

inch (3.4 mm) pilot holes

for the fixing screws

Cradle at fixed position

Countersink the pilot holes to prevent

damage to the mounting surface.

Use the three No. 8 screws to secure

the cradle to the mounting surface

Document: 87042-6

Date: 08-2020

www.raymarine.com

PAGE 1
Base Station & Wireless Controller Installation guide Parts supplied Fitting remote Base Station Tools Required S100 Remote Cradle at fixed position OR Smart Controller S100 REMOTE 2. Drill three 1/8 inch (3.4 mm) pilot holes 1. Mark holes for the fixing screws. MODE for the fixing screws STANDBY PILOT Power Drill No. 6 size MODE STANDBY PILOT Cradles x2 No. 8 size Self-tapping screws 3 Way Connector Block Cradles x2 Pozidriv screwdriver 1/ inch (3.
PAGE 2
Connecting Base Station to SeaTalk system Fitting Base Station 1. Remove cover 2. Mark holes for the fixing screws. 2 Important: Before connecting the Base Station, ensure that the 12 V supply on the asscociated SeaTalk system is protected by a 5 A fuse. SeaTalk bus Base Station For example, connect to an unused SeaTalk connector on an instrument Connect to Raymarine SeaTalk system 1 3. Drill two 7/64 inch (2.7 mm) pilot holes for the fixing screws 4.