User's Manual

ManualsBrandsRaven Industries ManualsElectronicsRemote Control Transmitter

EDR10488 4/05

Document Part No. 99300799

OPERATION GUIDE

MASSAGE NOTE:

When activated, the massage system will launch the prior intensity setting used and automatically

shut off after 30 minutes. To restart Neurosage wave, press the Neurosage on/off button. To restart

head or foot massagers, press the “+” symbol on the head or foot massage button/s.

IMPORTANT:

Read advisory information in the owners manual carefully before using this product. The

potential for electrical shock exists if electrical components are not installed or operated

properly.

See back of page for additional programming features...

FOOT UP/DOWN BUTTON

Press and hold to raise or

lower the foot section.

HEAD UP/DOWN BUTTON

Press and hold to raise or

lower the head section.

POSITION RECALL BUTTONS

Press to activate a position set

by the program button.

FLAT BUTTON

Press to return bed

to the level position.

HEAD MASSAGE BUTTON

Press the “+” symbol to activate the

head massager at a preset intensity.

Press and hold the “+” symbol to

intensify head massager. Press and

hold the “–” symbol to decrease head

massager intensity.

PROGRAM SET BUTTON

Press to capture any position

of the bed as a programmed

position (3 unique positions).

Press the recall buttons (“P1,

P2 or P3”) to return bed to

any of the preset positions.

To Program Preset Positions:

1. Set the head and/or foot to

the desired position.

2. Press the program set button

once.

3. Press position recall button

“P1” to save position.

4. Repeat steps 1 thru 3 above

to program favorite positions

for “P2” and “P3”.

TRANSMISSION

INDICATOR LIGHT

FOOT MASSAGE BUTTON

Press the “+” symbol to

activate the foot massager at

a preset intensity. Press and

hold the “+” symbol to

intensify foot massager. Press

and hold the “–” symbol to

decrease foot massager

intensity.

STOP BUTTON

Press to immediately stop

all active bed functions.

NEUROSAGE ON/OFF BUTTON

Press to activate or deactivate

the Neurosage wave vibration

system.

NEUROSAGE WAVE INTENSITY BUTTON

Press and hold the “+” symbol to intensify

Neurosage wave intensity. Press and hold

the “–” symbol to decrease Neurosage

wave intensity.

www.lpadjustablebeds.com

Summary of content (3 pages)

PAGE 1
OPERATION GUIDE TRANSMISSION INDICATOR LIGHT HEAD UP/DOWN BUTTON Press and hold to raise or lower the head section. PROGRAM SET BUTTON Press to capture any position of the bed as a programmed position (3 unique positions). Press the recall buttons (“P1, P2 or P3”) to return bed to any of the preset positions. To Program Preset Positions: 1. Set the head and/or foot to the desired position. 2. Press the program set button once. 3. Press position recall button “P1” to save position. 4.
PAGE 2
4002 PROGRAMMING To set channels on a single base: 1. Plug the bed into a power source and within 30 seconds, press the head up button on the hand control until the transmission indicator light illuminates. This will confirm that the hand control and the bed are communicating. 2. The hand control channel is now programmed. To set channels for 2 or more beds to operate independently: 1. Unplug all beds from their power sources. 4002 BATTERY REPLACEMENT Requires (2) CR2032 3 volt batteries. REMOVAL: 1.
PAGE 3
Re: Certification for Raven Transmitter Model(s): E1003925 FCC ID: KSME1003925 IC: 2004A-E1003925 USER'S MANUAL INFORMATION (PRELIMINARY) The User's Manual is in preparation. The following material will also be contained in the manual: WARNING: Changes or modifications not expressively approved by the party responsible for compliance could void the user's authority to operate the equipment.