User's Manual

User’s
Manual
mounting
the
sensor
*Before mounting the sensor,
secure the bicycle so that it does
not shake or fall over.
- mounting the sensor
1. Mount the sensor on the wheel
hub as shown in figure.1
(*If you mount the sensor on a
n asymmetric hub, the sensor
may tilt, but it does not affect
the performance of the device.)
2. Spin the wheel once to check if
it is mounted properly. And
connect to the app or the
device that support Bluetooth.
Pairing and
sensor activation
*figure.1
mounting speed sensor
• It is a solar speed sensor that
can be charged at any time in
sunny weather.
• The gravity measurement
method is applied.
• Lithium-ion battery is used and
can be used semi-permanently
without purchasing a battery.
1. Consult your Bluetooth smart
device’s instructions for pairing.
Sensor will need to be activated
by shacking sensor.
( *It supports Bluetooth.)
2. When the sensor is connected
to the device, the LED blinks 5
times.
3. If the sensor does not move for
about 1 minute, it automatically
turns off.
4. The sensor detects movement
and automatically operates.
5. If a problem occurs with the
sensor, please reset the sensor.
(*Reset the sensor by tapping a
magnet on it.)
기기의 명칭 :
특정소출력무선기기(무선데이터통신시스템용
무선기기)
The wireless device may not provide services related
to human safety because of possible radio
interference.
For additional information or explanation, you can
contact KakaoTalk Plus friend 'trimm'.
Notes
<FCC Compliance>
This device complies with part 15 of the FCC Rules.
Operation is subject to the following conditions:
(1) This device may not cause harmful interference.
and
(2) This device must accept any interference
received, including interference that may cause
undesired operation.
Any changes or modifications (including the
antenna) made to this device that are not expressly
approved by the manufacturer may void the user’s
authority to operate the equipment.
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the
equipment and receiver.
—Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.—Consult the dealer or an
experienced radio/TV technician for help.
Solar
speed sensor
Manufacturer
Item
Model
FCC ID
Power
Ratio LLC
Trimm Sensor
Trimm Sensor
2AUCE-TRIMMSENSOR
DC 3.7 V