+++ RASTAR RASTAR GROUP Manufactured In China under licence from Bentley Motors Limited England. "Bentley" , the 'B' in wings device and other associated logos and names are trademarks of Bentley Motors Limited. The body designs of Bentley motor cars are protected by Bentley Motors Limited under design, trademark and intellectual property law. Licensee: RASTAR GROUP Manufacturer: XINGHUI BABY SUPPLIES CO.,LTD. Add : North Area, Zhaoan Industrial Park, Zhengzhou, Fujian, China. Http://www. rastar.
•++ RASTAR RASTAR GROUP Bentle~ Continental GT S~ee~ Converti~le Ride-on Instruction The packing has to be kept since it contains important information.
CONTENTS ABOUT "RASTAR BABY'' PRODUCT-- - - - - - - -- - -- 01 SPECIFICATION 02 PARTS 03 ASSEMBLY 04 REPLACE BATTERY OF TRANSMITTER AND STEERING WHEEL 06 NORMAL OPERATION 07 STORAGE BATIERY MAINTENANCE 07 OVERCURRENT PROTECTOR 08 OPERATING FUNCTION 08 WARNING 10 CARE AND MAINTENANCE 11 MALFUNCTION SHOOTING GUIDE 11 RIDE-ON ELETRICAL ILLUSTRATION 12 MAINTENANCE 13 ABOUT "RASTAR BABY" PRODUCT Thank you for purchasing our products.
SPECIFICATION Size ( 120x60x47 .4 )cm For child 37months old - 96months old Max.weight loaded 30kg Net Weight 12.9kg Power Rechargeable Speed D1 (2-3)km/h 02 (3-4)km/h Battery 12V 7Ah lead-acid Power supply I I nput:AC100-240V 50Hz Output: DC15V 1OOOmA Subject to the nameplate of the charger I Charging period Charged for (8-10)h/time Run for (60-70)min Rechargeable times More than 300 For temperature 5-35 Celsius degree Power of Motor DC12V 25Wx2 PARTS NO. Desc. Qty NO. Desc.
~~ ~~3. ,-e ~~ ~ The serial number of all spare parts showed as "(NO.) • in the following desaiptions. II If the quantity and shape of some spare parts in this manual are different from that of products you buy, it might be because some parts of the car you buy already have been installed or because we reduce setup steps and quantities of spare parts for making the installing easier. Please check and review.
ASSEMBLY 1.1 nstall battery and power supply • • • * Put the storage battery into the battery compartment. Plug the interface to the jack.connect the red terminal and the black terminal respective ly to the anode andcathode of battery. (Notice: make sure they are correctly connected , red to red,black to black, otherwise, it will cause short-circuit.
3.lnstall steering wheel • Remove the protector (5) at the upside of the axes, which is non-functional but only for protecting use during the transportation . P lease dispose properly. •Please install the steering wheel (1) to the specific place and use Screw (9) and Hexnut (10) to screw it tightly after you make sure the steering wheel is in the right place. Please see picture 4. 4.lnstall windshield and wing mirror 1------~;;::~~;;~ • Install windshield(2) to the designated position, and a.
Replace battery of transmitter and steering wheel m 1.Raplace batt8I y of transmitter sin.lid ocnrb the eledri:al sooroe. •Put the antenna into the controller socket. • Please 1ake out ba!Bies il case leakage Open the lid and put the W tBklry axmii"g al:! cxmBrl If~ term sbage. bits polarity,then dose the lid. • Pease~ aJ OO!Be;Ykien I is fXMe"df. 2.Rew. . •lllMl!lyd •The cxrdl'Olersln.lld be operated by a:Julls •Please take doMl the battery CXMl'axn
NORMAL OPERATION Indicator Charging socket • • Charging socket is under the filler cap. Open the filler cap and injksert the plug of charger, then connect the charger with power. • Every one hour' s running needs 8 to 10 hours' charging. Every single charging can not over 24 hours. • Both charger and storage batteries will occur mildly warm during charging. • Do not use mal-functioned adapter or storage battery unless they are repaired.
OVERCURRENTPROTECTOR • Overcurrent protector is installed under the seat. • Rear matt is eqc lipped 'Nilh self-recxJVel)' fuze.Once overloading or improper operation happens , the fuze wi l I automatically cut off the power. Please turn the key off and wait for 30 seconds, then the fuze will recover automatically. • Power device is equipped with blown fuze. When short-circuit happens, the fuze will be blown. Therefore, after solve the circuit problem, you need to replace the blown fuze.
------@~0-----------------------· . } Indicator i Radio control/ Accelerator/ Play built-in ! Battery operated Sound i Mode Switch Headlight Switch Volume Switch Insert the key into the key hole, then tum the key until you hear a click sound. Forward at high speed: put the Gear Switch in 02 gear and step on pedal switch, the ride-on will move forward at high speed. Forward at low speed: put the Gear Switch in 01 gear and step on pedal switch, the ride-on will move forward at low speed.
WARNING Please read carefully since it contains important information. • Chlldren are not allowed to operate charging. It should be operated by adult. • Ride-on operation should be under adults' supervision. • This product should be assembled by adult; or checked by adult to make sure proper assembly. • It is prohibited to run this ride-on in public streets, roads, slope, near swimming pool, or any other dangerous area. •This ride-on can not be overloaded. The maximum loading capacity is 30 kilograms.
• • • • • can be recharged under adults' supervision; Rechargeable batteries are to be taken out from ride-on during charging. When batteries are short of power, the remote control distance will be shorten. Please replace with new batteries. Take out batteries if ride-on is not in use for an extended preriod in case liquid leakage. Remove batteries when they are used up. Supply terminals are not to be short-circuit.
Malfunction Analysis Solution • Car is damaged • Please ask after-sale service for help • Battery is not fully charged • Battery is over used •Re-charge • Replace battery Faint sound and heat occurs when charging battery • Chemical reaction •Normal reaction Gear box is noisy • Gear is broken •Please ask after-sale service for help • Car power switch is off • Battery is power-off • Tum on the power switch • Charge the battery • Charger is broken • Please ask after-sale service for help Car c
MAINTENANCE • This product comes with maintenance service. • Maintenance fee is required for product malfunction caused by improper operation or man-made factor, or if it has exceeded guarantee. • Maintenance service can be provided by the sellor andus. Invoice, mai'1le-ance record and malfunctioningproducVpart(s) will be required. MAINTENANCE RECORD Date Details Customer Name: Result --------- Address: Invoice NO.
changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.