Spec Sheet

Industrial Sizes
1/2” 3/4” 1”
ax
LINE
Compressed Air Piping System
300
250
200
150
100
50
1” Maxline (1.02 Inside Diameter)
at 150 psi, 10 psi pressure drop
50 100 150 200 250 300
300
250
200
150
100
50
3/4” Maxline (.80 Inside Diameter)
at 150 psi, 10 psi pressure drop
0 50 100 150 200 250 300
Operating Pressure
175 psi at 70°F
140 psi at 140°F
Meets OSHA
guidelines
Temperature range
-40°F to 140°F
Compatible with
common compressor oils
3) PUSH the fitting onto the
tubing and fully against the
shoulder of the fitting (soapy
water will help this process)
5) TIGHTEN nut with
wrench a minimum of
ONE FULL TURN
- Nickel plated brass
- Double o-ring design
- Split ring allows disassembly
- No expensive tools required
HDPE
Aluminum
HDPE
1/2” Maxline (.48 Inside Diameter)
at 150 psi, 10 psi pressure drop
60
50
40
30
20
10
1) CUT the tubing square
with the cutter, ROTATING
wrist while cutting
2) BEVEL the inside of
the tubing by inserting the
reaming tool and rotating
it at least 3 full turns.
Remove nut and split ring
from fitting and place
on tubing
4) TURN the nut finger
tight Put a reference mark
on the nut and fitting body
WARNINGS:
• Compressed air is dangerous if not used properly.
• Do not point compressed air source at any
part of your body or at any person.
• Always use eye protection when using compressed air.
• Turn off compressor when not in use.
• CA Prop 65: This product contains chemicals known to the state of
California to cause cancer and birth defects or other reproductive harm
1-800-954-3310 • www.rapidairproducts.com
Engineered
Specialties
LLC
Arpin, Wisconsin
Tools and installation