Specification

1
PRODUCT DATASHEET
DESCRIPTION: Rapid Set
®
FLOW CONTROL
®
is a ow enhancing additive that allows
higher uidity or lower water requirement. Reducing water content by adding FLOW
CONTROL will increase the nal strength and durability.
USES: Use FLOW CONTROL with Rapid Set cement products. Add 1 to 4 packets of FLOW
CONTROL to increase uidity, and/or increase strength to satisfy jobsite requirements.
A trial batch is recommended to ne-tune the dosage. FLOW CONTROL may be used in
combination with all other products of the Rapid Set
®
Concrete Pharmacy
®
.
DIRECTIONS: Place desired amount of potable water into mixing container. Add half
cement product into mixing container and mix with mechanical drill/mixer. Continue
mixing while adding FLOW CONTROL 2.1-oz (60-grams) powder to mixing container. Add
remaining cement product into mixing container. Follow product mixing instructions and
maximum water requirements described on the package of the cement product. Mix to
a workable, lump-free consistency. Do NOT exceed 4 packets per 50-lb to 70-lb bag of
Rapid Set branded cement product. Too much water in the mixture may cause aggregate
segregation, which can reduce strengths.
SHELF LIFE: FLOW CONTROL has a shelf life of 12 months when stored properly in a dry
location, protected from moisture, out of direct sunlight, and in an undamaged package.
USER RESPONSIBILITY: Before using Rapid Set products, read current technical data
sheet, bulletins, product label and safety data sheet at www.CTScement.com. It is the
user’s responsibility to review instructions and warnings for any Rapid Set product in
current technical data sheet, bulletins, product label and safety data sheet prior to use.
WARNING: CAUSES MILD SKIN IRRITATION. MAY BE HARMFUL IN CONTACT WITH
SKIN. CAUSES SERIOUS EYE IRRITATION. Protect eyes with goggles or safety glasses
with side shields. Cover skin with protective clothing. Use chemical resistant gloves and
waterproof boots. In case of skin contact, immediately wash with soap and water. In
case of eye contact, ush immediately and repeatedly with clean water, and consult a
physician. Use a NIOSH/MSHA approved respirator if there is a risk of exposure to dust/
fume at levels exceeding the exposure limits.
Please refer to the SDS and www.CTScement.com for additional safety information
regarding this material.
LIMITED WARRANTY: CTS CEMENT MANUFACTURING CORP. (CTS) warrants its materials
to be of good quality and, at its option, will replace or refund the purchase price of any
material proven to be defective within one (1) year from date of purchase. The above
remedies shall be the limit of CTS’s responsibility. Except for the foregoing, all warranties
expressed or implied, including merchantability and tness for a particular purpose, are
excluded. CTS shall not be liable for any consequential, incidental, or special damages
arising directly or indirectly from the use of the materials.
L WARNING
CANCER and REPRODUCTIVE HARM - www.P65Warnings.ca.gov
FLOW CONTROL
®
Additive to Increase Strength and Fluidity
OVERVIEW
Highlights:
For use with Rapid Set
®
cement products
Water reducing additive
Increases uidity
Increases compressive strength
Manufacturer:
CTS Cement Manufacturing Corp.
12442 Knott St.
Garden Grove, CA 92841
Tel: [phone] | Fax: [phone]
Web: www.CTScement.com
E-mail: [e-mail]
ADDITIVESPRODUCT CATALOG