SM-PROJ-XL-WH / SM-PROJ-XL-BLK Strong™ Fine Adjust Projector Mount INSTRUCTION MANUAL
SM-PROJ-XL Installation Manual 1. Warnings and Important Safety Instructions CAUTION: This ceiling mount is intended for use only with the maximum weight of 50 lbs (22.67 kg). Use with heavier than the maximum weight indicated may result in instability causing possible injury. • • • • • 2. Pg. 2 We highly recommend this product be installed by a qualified professional. Do not begin installation until you thoroughly read and understand these instructions.
SM-PROJ-XL Installation Manual 3. Introduction Thank you for purchasing a Strong® projector mount. We appreciate your purchase and are committed to providing the highest quality products possible. This Strong SM-PROJ-XL Projector Mount was designed to provide the most installer-friendly experience possible. It uses a hanging mount design that allows for easy height adjustment using standard 1.
SM-PROJ-XL Installation Manual 5. Tools Required • • • • • • • • 6.
SM-PROJ-XL Installation Manual Step 2. Install the Mounting Plate or Accessory on the Ceiling If an alternative ceiling mounting accessory is being used to hang the mount from the ceiling, refer to the installation manual included with it to complete step 2 of SM-PROJ-XL installation. If the included ceiling plate is being used, continue with the directions below for either wood or masonry ceiling material mounting.
SM-PROJ-XL Installation Manual Step 3. Attach the Projector Mount Body and Optional Extension Accessories A. I f no adapters or accessories are being used, thread the projector mount body (B) into the ceiling plate (A) by hand as tight as possible while still pointing toward the screen correctly, and then skip to step C. Figure 5 (A) B.
SM-PROJ-XL Installation Manual Step 5. Attaching the Mounting Base Assembly to the Projector After the center of balance is found, the mounting base assembly must be attached to the projector. Attachment will vary for almost every projector, so the position of the arms can be re-configured as needed. A.
SM-PROJ-XL Installation Manual Step 6. Hanging the Projector After the projector has been attached to the mounting base, it can be attached to the projector mount body. Figure 10 1. Lift the projector and position the front lip of the mounting base (C) at the bottom-rear of the mount body (B), and slide it into the opening. (Figure 10) (B) (C) The mounting base should slide into the body with ease with the rails engaged on both sides.
SM-PROJ-XL Installation Manual Step 7. Adjusting the Projector Image Now that the mount and projector are fully assembled and installed, make all connections and power on the projector. Display an image from a source or a pattern generator so that final adjustments can be made. See Figure 13 below for reference. Move each knob in the desired direction until the image is properly aligned.
SM-PROJ-XL Installation Manual 8. Specifications General Color White or Black Finish Type Powder Coated, Matte Finish Product Weight 5 lbs. Security Features Includes security hardware for attaching projector Certifications UL Compatibility Maximum Projector Weight 50 lbs. Minimum Mounting Pattern 1.96” x 1.96” (50mm x 50mm) Maximum Mounting Pattern 17.71” x 17.71” (450mm x 450mm) Adjustments 9.
SM-PROJ-XL Installation Manual 10. Warranty Lifetime Lifetime Limited Warranty Strong™ Mounts have a Lifetime Limited Warranty. This warranty includes parts and labor repairs on all components found to be defective in material or workmanship under normal conditions of use. This warranty shall not apply to products which have been abused, modified or disassembled.
© 2013 STRONG™ 130801-1355
