User's Manual

ManualsBrandsRanger Electronic Communications ManualsElectronicsAM 40 CH CB Transceiver

ELITE ONE

CITIZENS BAND

AM Mobile Transceiver

Owner’s Manual

- 1 -

CONTENS

PAGE

Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

Location . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

Mounting The Radio . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

Ignition Noise Interference . . . . . . . . . . . . . . . . . . . . . . . 4

Antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Tuning The Antenna for Optimum SWR . . . . . . . . . . . . . 5

External Speaker . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6

Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7

Front Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7

Rear Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Frequency Chart . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9

Procedure to Receive And Transmit . . . . . . . . . . . . . . . . 10

Alternate Microphone And Installation . . . . . . . . . . . . . . 11

Maintenance And Adjustment . . . . . . . . . . . . . . . . . . . . 12

A Few Rules That Should Be Obeyed . . . . . . . . . . . . . . 13

How Your CB Can Serve You . . . . . . . . . . . . . . . . . . . . . 14

Summary of content (10 pages)

PAGE 1
ELITE ONE CITIZENS BAND AM Mobile Transceiver Owner’s Manual CONTENS A Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . PAGE 2 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Location . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Mounting The Radio . . . . . . . . . . . . . . . . . . . . . . . . . . . . Ignition Noise Interference . . . . . . . . . . . . . . . . . . . . . . . Antenna . . . . . . .
PAGE 2
SPECIFICATIONS A GENERAL Model Channels Frequency Range Emission Frequency Control Frequency Stability Temperature Range Antenna Impedance Antenna Connectors Input Voltage Size Weight A LOCATION ELITE ONE 40 26.965 ~ 27.405 MHz AM Phase-Lock-loop (PLL) Synthesizer 0.001% -30°C to +50°C 50 Ohms Standard SO-239 type 13.8V DC 190 (W) x 120 (D) x 31 (H) m/m 1 kg.
PAGE 3
INSTALLATION A INSTALLATION A IGNITION NOISE INTERFERENCE TUNING THE ANTENNA FOR OPTIMUM S.W.R Even though the transceiver has ANL and NB controls, in some installation ignition interference may be high enough to make good communications impossible. The electrical noise may come from several sources. Many possibilities exist, as variations between vehicles require different solutions to reduce the noise. A. 1. Antenna with adjustment screws (set screws).
PAGE 4
INSTALLATION A If you’re having difficulties in adjusting your antenna, check the following: a. b. c. d. e. f. OPERATION A FRONT PANEL All doors must be closed when adjusting the antenna Make sure the antenna base is grounded. Check your coaxial cable routing (it may be pinched when routed into the car) Try a different location in your car (keeping in mind the radiation pattern you wish.) Is the antenna perfectly vertical? Try a different location in your neighborhood.
PAGE 5
OPERATION A OPERATION A REAR PANEL 7. RX LED: The red LED indicates the unit is in the transmit mode. The green LED indicates the unit is in the receive mode. 8. CHANNEL DISPLAY: The channel display indicates the current selected channel 1. EXT. SP: This jack accepts 4 to 8 ohms, 5 watts external speaker. When the external speaker is connected to this jack, the built-in speaker will be disabled. 2. DC POWER: This accepts 13.8V DC power cable with built-in fuse.
PAGE 6
OPERATION A OPERATION A PROCEDURE TO RECEIVE AND TRANSMIT FREQUENCY CHART A. MICROPHONE The receiver and transmitter are controlled by the push-to-talk switch on the microphone. Press the switch the transmitter is activated, release switch to receive. When transmitting, hold the microphone two inches from the mouth and speak clearly in a normal voice. This transceiver comes complete with a low impedance dynamic microphone. Channel Channel Frequency Channel Channel Frequency 1 26.965 MHz 21 27.
PAGE 7
OPERATION A ALTERNATE MICROPHONES AND INSTALLATION For best results, the user should select a Condenser type microphone. The microphones must be provided with a four-lead cable. The audio conductor and its shielded lead Comprise two of the leads. The third lead is for transmit control and fourth is for receiving Control The microphone should provide the functions shown in schematic below.
PAGE 8
OPERATION A 5. The wires must now be soldered to the pins as indicated in the above wiring tables. If a vise or clamping tool is available it should be used to hold the pin receptacle body during the soldering operation, so that both hands are free to perform the soldering. If a vise or clamping tool is not available, the pin receptacle body can be held in a stationary position by inserting it into the microphone jack on the front panel.
PAGE 9
MEMO OPERATION A A FEW RULES THAT SHOULD BE OBEYED 1. You are not allowed to carry on a conversation with another station for more than five minutes at a time without taking a one-minute break, to give others a chance to use the channel. 2. You are not allowed to blast others off the air by over-powering them with illegally amplified transmitter power, or illegally high antennas. 3. You can’t use the transceiver to promote illegal activities. 4. You are not allowed to use profanity. 5.
PAGE 10
MEMO Printed in China AT7799010OI - 18 - - 19 -