User's Manual

Table Of Contents

Phone case that contain metal, magnets,

or are thicker than 3mm will interfere with

wireless charging.

This charger is designed for Qi-compatible

devices. If your phone does not have built-in

wireless charging capabilities, please use a

certified Qi wireless charging case or receiver.

Refer to your phone’s user manual for detailed

features and functions.

1.We suggest to use QC2.0 or QC3.0 adapter

for fast charging.

2.Do not place metal objects, magnets,

magnetic stripe cards, and hard drive based

devices near the wireless charger. It may

cause data corruption.

3.Do not attempt to modify, disassemble, or

repair this product.

4.Do not expose to water, moisture,

or extreme temperatures

( below 40℉ or above 90℉)

Wireless Charging

Position your phone in the center of the

designated charging area. You phone will

indicate when charging begins.

MANUAL

Ram Mounts

Quick Grip Charger

Model # - RAM-B-166

1. Can be customize

2. Diameter=50mm,can be customized

3. Input Power:10W 5V-2A; 9V-1.67A

4. Output: 5W / 7.5W / 10W

5. Conversion Efficiency: 85% Max

6. Transmitting Distance: 5-8mm

7. Working Frequency: 115-205KHz

8. Product Standard: WPC v.1.2.4

9. Protective measures: FOD,DPL,SCP,Over temperature,over

voltage protection, software/hardware dual over current protection

enhanced VRVS;Dedicated high power low loss MOS & MOS driver

10. Compatible for:QC2.0/QC3.0

PAGE 1
MANUAL Model # - RAM-B-166 Ram Mounts Quick Grip Charger 1. Can be customize 2. Diameter=50mm,can be customized 3. Input Power:10W 5V-2A; 9V-1.67A 4. Output: 5W / 7.5W / 10W 5. Conversion Efficiency: 85% Max 6. Transmitting Distance: 5-8mm 7. Working Frequency: 115-205KHz 8. Product Standard: WPC v.1.2.4 9. Protective measures: FOD,DPL,SCP,Over temperature,over voltage protection, software/hardware dual over current protection enhanced VRVS;Dedicated high power low loss MOS & MOS driver 10.
PAGE 2
FCC warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
PAGE 3
IC Caution: Radio Standards Specification RSS-Gen, issue 5 - English: This device contains licence-exempt transmitter(s)/ receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: This device may not cause interference. This device must accept any interference, including interference that may cause undesired operation of the device.