User's Guide

ManualsBrandsRajant ManualsElectronicsmini-PCI radio Module

745 Toa Payoh Lorong 5, The Actuary, Suite 04-01, Singapore 319455

User Guide for OEM Integration

Model : DLM108-RJT

Brand : Doodle Labs

DLM108-RJT is an Industrial grade 1000 mW Tx power mini-PCI radio module. It

is designed for the ISM frequency band 902 MHz ~ 928 MHz. It sports

advanced filtering and noise reduction design techniques for high

interference immunity from the neighboring Pager transmitters.

Applications

z Long Range Outdoor Broad band wireless applications

z Back hauls

z Access points & High Performance CPEs

z Mesh Wireless Infra structure applications

z Industrial applications

Summary of content (6 pages)

PAGE 1
User Guide for OEM Integration Model : DLM108-RJT Brand : Doodle Labs DLM108-RJT is an Industrial grade 1000 mW Tx power mini-PCI radio module. It is designed for the ISM frequency band 902 MHz ~ 928 MHz. It sports advanced filtering and noise reduction design techniques for high interference immunity from the neighboring Pager transmitters.
PAGE 2
RADIO SYSTEM INFORMATION Model No* DLM108-RJT MAC and Baseband Atheros AR5414A Interface 32bits, 33MHz miniPCI Type III A Operation Voltage 3.
PAGE 3
Tx/Rx Specification 20 MHz Channel BW (FULL RATE) 912 MHz & 917 MHz Data Rate Modulation Tx Power* (± 1 dBm) Rx Sensitivity (± 2 dBm) 1 Mbps DBPSK/DSS 30 dBm -97 dBm 2 Mbps DQPSK/DSS 30 dBm -95 dBm 5.
PAGE 4
Interference Signal Desensitization Measurements DLM108-RJT Operating Freq = 917 MHz, 20 MHz Channel, BPSK/COFDM Modulation Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 5
o o Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules.
PAGE 6
End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: “Contains FCC ID:VJADLM108RJT& IC: 7832A-DLM108RJT”.