SU Pro, SU Air Outdoor Subscriber Radio Unit REFERENCE GUIDE
Regulatory Compliance FCC/IC - Compliance This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules and IC RSS standards. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Prudence Les unités extérieures et les antennes doivent être installés que par des professionnels expérimentés d'installation qui sont familiers avec les normes locales et les codes de sécurité et, si applicable, sont agréées par les autorités gouvernementales de réglementation compétents. Ne pas le faire peut annuler la garantie du produit et peuvent exposer l'utilisateur final ou le fournisseur de services d'obligations juridiques et financiers.
Overview The ‘SU Pro, SU Air’ is an Outdoor Subscriber Radio Unit operating in the 4.9 – 5.8 GHz frequency bands. It is a TDD OFDM radio supporting 10 MHz, 20 MHz, 40 MHz and 80 MHz channel bandwidths. The 2.4 GHz WiFi interface supports standard 802.11/n HT-20, HT-40 operation modes. It supports cross polarized 2x2 MIMO antenna configuration for PtP and PtMP systems. The ‘SU Pro, SU Air’ also features an on-board WiFi 2.4 GHz interface module for short range control purposes.
Maximum Output Power 5725 – 5850 MHz band - FCC/IC The maximum output power can be set as follows, when operating in the 5.8 GHz band, under FCC 47 CFR Part 15.407 New Rules and IC RSS-247 regulations. The power values are for PtP systems and PtMP systems. For PtMP systems the total EIRP is limited to 36 dBm. Therefore the output power of these systems will be reduced to comply with 36 dBm EIRP limit.
Radio parameters accessed by end-user The following parameters can be accessed by user: 1. Output Power 2. Frequency channel 3.