AP0260210 5 GHz MS RF Module REFERENCE GUIDE
Regulatory Compliance FCC/ISED - Compliance This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules and ISED RSS standards. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Prudence Warning Avertissement Les unités extérieures et les antennes doivent être installés que par des professionnels expérimentés d'installation qui sont familiers avec les normes locales et les codes de sécurité et, si applicable, sont agréées par les autorités gouvernementales de réglementation compétents. Ne pas le faire peut annuler la garantie du produit et peuvent exposer l'utilisateur final ou le fournisseur de services d'obligations juridiques et financiers.
Overview The AP0260210 is an RF module operating in the 5.1 and 5.8 GHz frequency bands. It is a TDD OFDM radio supporting 20 MHz, 40 MHz and 80 MHz channel bandwidths. It is a 2x2 MIMO transceiver, with two RF interfaces capable of toggling between them. The MS RF module cannot work as a stand-alone device. It can operate and be controlled only when installed in a host enclosure manufactured by RADWIN. The MS RF module is certified as a limited modular approval type under the FCC ID: Q3K5XACMODMS.
Antennas Following is the list of antennas supported by the AP0260210 5 GHz MS RF Module: Antenna Max Gain (dBi) Antenna Type Manufacturer Model Number 5.1 GHz 5.8 GHz Sector Dual Pole Integrated 90 Deg RADWIN Integrated 14 16 Flat Panel Dual Pole Integrated RADWIN MT0105940 16 16.
Labelling Requirements The module is labeled with the identification numbers as follows: FCC ID: Q3K-5XACMODMS IC: 5100A-5XACMODMS The host into which the module is assembled is labeled as follows: Contains FCC ID: Q3K-5XACMODMS Contains IC: 5100A-5XACMODMS AP0260210 Reference Guide 3