User's Manual

Cat. No. 15-1950

OWNER'S MANUAL

Please read before using this equipment.

Wireless IR Remote Extender

Thank you for buying the RadioShack Wireless IR Remote Extender. The extender increases

your existing remote control’s operating range. The extended range lets you control your TV,

VCR, stereo, CD player, or cable converter from greater distance than normally possible with

existing remote controls without concern for line-of-sight requirements.

Features include:

Full remote Control Compatibility  receives, converts, and relays infrared signals from virtually

any infrared remote control.

Powerful Radio Frequency  lets you control audio/video equipment from up to 100 feet away,

even from another room in your house.

[warning and caution (risk of electric shock) wordings here]

[lightning and exclamation wordings here]

INSTALLATION

Your RadioShack Wireless Infrared Remote Control Extender includes a transmitter and a

receiver. The transmitter senses the infrared signals from your audio/video equipment’s remote

controls and converts them into wireless transmissions. The receiver senses these transmissions,

converts them back into identical infrared signals then relays them to your audio/video equipment.

Installing the Receiver

Follow these steps to install the receiver.

1. Place the receiver in front of the audio/video equipment and position it:

o Within 20 feet of the audio/video equipment’s remote sensor

o With the receiver’s front directly in front of the audio/video equipment’s remote sensor

2. Fully extend the telescopic antenna.

Note: Rotate and adjust the receiver’s telescopic antenna for the best reception when you

use it for the first time.

PAGE 1
Cat. No. 15-1950 OWNER'S MANUAL Please read before using this equipment. Wireless IR Remote Extender Thank you for buying the RadioShack Wireless IR Remote Extender. The extender increases your existing remote control’s operating range. The extended range lets you control your TV, VCR, stereo, CD player, or cable converter from greater distance than normally possible with existing remote controls without concern for line-of-sight requirements.
PAGE 2
3. Connect the supplied AC adapter’s barrel plug into the DC 12V jack, then connect the adapter’s AC plug to a standard AC outlet. Cautions: o You must use a Class 2 power source that supplies 12V DC and delivers 120 mA. Its center tip must be set to positive and its plug must fit the receiver’s DC 12V jack. The supplied adapter meets these specifications. Using an adapter that does not meet these specifications could damage the receiver or the adapter.
PAGE 3
Note: The extender system’s LEDs (particularly the transmitter’s) might blink occasionally. This is caused by interference in the local vicinity and is normal. [THE FCC WANTS YOU TO KNOW wordings here] [CARE wordings here] SPECIFICATIONS Power Supply 120VAC/60Hz, 12VDC/120mA Transmitter Transmit Frequency Modulation Type Transmit Power (EIRP) Frequency Accuracy Remote Range (R/C to TX) Extension Range (TX to RX) 418 MHz ASK 1mW (FCC) ±1 MHz 20 Feet, Vertical ± 30°/Horizontal ± 15° . 100 Feet Min.