User's Manual

Your remote control is powered with a button-cell
battery (included), to install the battery:
1. Press and push open the battery compartment
cover.
2. Insert the CR2032 battery with positive polarity
(+) facing up into the remote control then
replace the cover.
battery notes
• Keep button-cell away from small children. If
swallowed, promptly see a doctor. Have the
doctor call 202-625-3333 collect.
• Do not open the battery; or dispose of it in a
fire; or recharge; or insert backwards. It may
explode or leak, causing personal injury.
• Use only fresh batteries of the required size and
recommended type.
• If you do not plan to use your remote control for
a week or more, remove the batteries. Batteries
can leak chemicals that can damage electronic
parts.
Please read this user’s guide before
installing, setting up and using your new product
www.radioshack.com
installing batteries
indoor VHF/UHF/HDTV antenna
remote control
75 Ohm coaxial cable with gold plated connectors
power adapter
1 button-cell battery
user’s guide
what’s included
Microprocessor-Controlled Antenna Rotating
Control – Allows you to rotate the antenna in 12
distinct positions only in a few seconds, either
clockwise or counterclockwise for best UHF
reception.
100 Channel Memories - Allows you to select
up to 100 channels (0-99) and the corresponding
antenna position stored for that channel.
Built-in Amplifier Gain Control –
Allows you to
amplify weak signal.
other features
Thank you for purchasing the Indoor VHF/UHF/
HDTV Antenna with RF remote control from
RadioShack. Your antenna is perfect for improving
TV reception. You can retrieve stored channel
position with the RF remote control by simply
recalling one of the channel memories. Your
antenna will automatically move to the direction
you programmed for best reception.
For VHF TV Channels 2-6 and FM radio:
• Fully extend the telescopic antenna.
For VHF TV Channels 7-13:
• Retract the antenna to the appropriate length
and move to an angle that produces the best
reception
adjusting your antenna
15-1892
indoor VHF/UHF/HDTV antenna
with RF remote control
To select a second video source, such as cable TV,
a video game, or satellite dish signal, slide “AUX/
TV” switch to “AUX”.
selecting another source
battery
compartment cover
AUX/TV switch
Perfect for improving TV reception, this indoor
antenna boosts the best received signals to your
TV, so you can enjoy the best picture. You can also
use this antenna to improve FM radio reception
installing your antenna
1. Place the antenna on or near your TV set.
2. Connect the antenna’s TV output cable to your
TV’s or VCR’s input terminal.
3. Connect a second video source, if available,
to the AUX terminal using the 75 ohm coaxial
cable/connector.
4. Connect the supplied AC adapter’s barrel plug
into the DC jack on the back of the indoor
antenna, and connect the AC adapter’s other
end to a standard AC outlet.
CAUTION
You must use an adapter that supplies 12V DC
and delivers at least 350 mA. Its center tip must
be set to positive and its plug must fit this indoor
antenna’s jack. The supplied adapter meets these
specifications. Using an adapter that does not
meet these specifications could damage the
indoor antenna or the plug.
installing the antenna
DC 12V jack
AC-DC adaptor
Antennas