RADIOLINK DIGITAL PROPORTIONAL R/C SYSTEM OPERATING INSTRUCTIONS Before use please read these instructions completely
1 Introduction to the RL036T radio Thank you for purchasing Radiolink RL036T-001A four channel digital radio system it is a good quality radio and can be used in electric helicopter, engine aircraft, electric park-flying. It is important that you care fully read the manual before operate your moder . Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user authority to operate equipment.
2 RL036T TRANSMITTER Throttle actuator trim Elevator pitch of screws trim trim power and low battery display Antenna Hook Throttle actuator curve trim big and small rudder switch Undercarriage switch Drillmaster switch 3D switch Elevator/ Rudder stick. Throttle actuator /elevator aileron stick.
On/off Switch Aileron positive negative phase switch and Elevator positive and negative phase switch Rudder positive and negative phase switch Throttle actuator positive and negative phase switch
antenna Drillmaster switch handgrip 3D switch Trainer cord jack Battery Book cover battery storehouse (8pcs AA 1.
3 TRANSMITTER OPERATION LEFT RIGHT Aileron operation When the aileron stick is moved to the right,the right aileron is raised and the left aileron is lowered.relative to the direction of flight and the plane turns to the right.when the aileron stick is moved to the left.
is raised and the tail of the plane is forced down.the air floe applied to the wings is changed.the lifting force is increased,and the plane climbs(up operation) when the elevator stick is pushed forward,the elevator is lowered the tail of the please is forced up.the air flow applied to the wings is changed.
LEFT RIGHT Rudder operation When the rudder stick is moved to the right,the rudder moves to the right,and the nose points to the right,relative to the direction of flight.When the rudder stick is moved to the left,the rudder moves the left and the direction of travel of the plane changs. 4 CRYSTAL The crystal is soldered on PCB and cann’t be replaced by other type of crystal.
5 precautions during flight a) Do not fly simultaneously on the same frequency.Interference may cause acrash. *Use of the same frequency will cause Interference even if the modulation method(FM,PCM) is different. b) Do not fly in rainy or windy days water will penetrate into the transmitter and cause faulty operation,or loss of control,and cause acrash. c) Extend the antenna to its full length. If the antenna is too short, the effective range of the radio waves will become shorter.