Lad Cl ‘Speakerphones Jacks Antenna Power switch Volume control! LED Indicator ‘Speaker Microphone Noise Gangling Indicator Press the [NC] button to enable the scan function, then press any button to exit the scan mode; Press and hold the [NC] button for 3 seconds to ‘enable/disable the nose canceling bunion PTT Switch{Push To Talk) Press the [Channel+] to dissect channel upward, press and hold the button for 3 seconds fo tum nonfood the VOX function
8 Er ———y Do Press the [Channel-] to select channel downward, 11 | press and hold the button for 3 seconds to tum on/off the Monk or function 12_| USB Charging Port Installing Charging the Battery the Battery Pack Installing Installing the the Belt Clip Speaker/Microphone
SET TO Functions and Operations Powering Onion Tum the Volumetric Knob clockwise to which the transceiver power ON til a click Is heard Selecting a Channel Press UP/DOWN Key to select a desired channel. Press UP key to increase the channel, press DOWN key to decrease the channel PTT {push to talk) Button Crass this key , then speak into the microphone to call. Release Ito receive Squelch Level (Programmable on PC) You can program the squelch level.
SET TO Time-out Timer(TOT) (Programmable on PC) The purpose of the Time-cut Timer Is to prevent any caller from using a channel for an extended period of time. If you continuously transmit for & period of ime that exceeds the programmed time set by programming software, the transceiver will stop transmitting and an alert tone wil sound. To lop the tone, reseals the PTT key.
SET Busy Channel Lockout) ‘When activated, BCL prevents you from interfering with ‘other parties who may be sing the same channel that you selected. Pressing the PTT switch while the channel Is In use will cause your transceiver to emit an alert tone and transmission will be inhibited(you cannot transmit). Release the PTT switch to stop the tone and rectum to receive mode. Note: Busy Channel Lockout shall be setup In PG: software.
SET TO elev, louder received signals may cause the transceiver to start transmission DCS Mode ‘You can setup DCS mode on each channel In PC software. There are two options: Normal and Special.