® Boundary Plus Single Loop Transmitter Owner’s Manual www.invisiblefence.
Important Precautions • Invisible Fence® Brand pet containment systems have contained over two million pets. However, there are some precautions you should take. • Read and retain manuals: Read the entire Owner’s Manual before using your new Invisible Fence® Brand pet containment system. • Adhere to all warnings and cautions contained in any Invisible Fence® Brand manual. This is the safety alert symbol. It is used to alert you to potential personal injury hazards.
Congratulations on your purchase of the world’s premier pet containment solution, the Invisible Fence® Brand. When professionally installed, the Invisible Fence® Brand pet containment system is backed with a one-year, money-back performance guarantee. The support of your Invisible Fence® Brand Dealer gives you peace of mind that your pet remains safe at home. Refer to the back of your sales contract for complete details. Table of Contents Components .........................................................
Components How the System Works The Boundary Plus® Single Loop Transmitter is designed to work with an Invisible Fence® Brand Computer Collar® Unit to contain your pet within areas you choose, or teach your pet to avoid specific areas such as flower beds, gardens, or pools. The transmitter produces a signal that travels along the signal field wire and back to the transmitter to produce an Invisible Boundary® barrier.
Transmitter Status Indicators Status Indicator Light: This is the only light visible outside the transmitter. The chart below explains the various Status Indicator Light conditions. Audible Alarm: There is an audible alarm for certain alert conditions (see chart below). Pressing either the Mode or CFG button on the transmitter circuit board will silence the alarm. The alarm will re-activate on power-up if a failure condition still exists.
Troubleshooting Symptom Pet is getting out. Possible Cause Action • Power Cap® Battery in the Computer Collar® unit is dead or weak. • Computer Collar® Unit is not fit properly on the pet. • Signal field wire has a break. • Power is not supplied to the transmitter or Power is out. • Pet needs additional training. • Replace the Power Cap® Battery. • Properly fit the collar. • Contact your Invisible Fence® Brand Dealer. • Make sure transmitter power supply is plugged in.
Compliance US and Canada Model: Boundary Plus® Single Loop Transmitter FCC ID: KE3-3002587-1 IC: 2721A-30025871 This device complies with Industry Canada license-exempt RSS standard(s). This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Dealer Name: Dealer Phone: Notes: 800-578-3647 (USA) (865) 777-5404 (International) 400-1700 ©2013 Radio Systems® Corporation All rights reserved. Protected by Patents: U.S.: #7,046,152, #7,565,885, #5,576,694 #7,117,822, Patents Pending Canada: #2173169 Australia: #2007202433 www.invisiblefence.