Outdoor Shields Plus Owner’s Manual www.invisiblefence.
Congratulations on your purchase of the Outdoor Shields Plus. Please read and review this manual to become familiar with Outdoor Shields Plus components and its operation. It is strongly recommended you review this information before using the product. Outdoor Shields Plus gives you control over the areas a pet or pets have access to outside your home. It is designed to work independently, or to complement your Invisible Fence® Brand 800 digital electronic pet containment system.
7. Do not attempt to service any Invisible Fence® Brand equipment. Refer all service to your authorized Invisible Fence® Brand Dealer only. Unauthorized service or repair will void the warranty. Note: The low battery indicator will begin flashing when it is time to replace the batteries. An Outdoor Shields® Plus transmitter producing less than the maximum setting will get a substantially longer battery life.
Operating Guide Important: Make sure your pet is not wearing the Computer Collar® unit when turning on the Outdoor Shields® transmitter. 1. Power up the Outdoor Shields Plus transmitter • Locate the battery door on the bottom of the Outdoor Shields Plus transmitter. Loosen the 4 Phillips head screws. The screws will stay in the battery lid. Install 4 alkaline Dbatteries (Not Included) and replace the battery door.
. Checking for low battery • Open the lid exposing the LCD display and buttons. • If the LCD display is flashing with all six black segments showing it is time to replace the batteries. • After replacing the batteries you will need to check and see if the range for the signal field is set to the desired area. 6.
Changing the Channel Setting on the Shields® Transmitter • Make sure the Range is all the way down. • Remove the battery door from the Outdoor Shields® Plus transmitter by loosening the 4 Phillips head screws. Remove the 4 D-batteries if you had already placed them inside the transmitter. • Select the desired Channel or Channels from the Channel (Chnl) Chart inside the upper battery cavity. • Locate switches 1 & 2 inside the lower battery cavity.
Note: If your problem cannot be solved by the Troubleshooting Guide above, call your Invisible Fence® Brand Dealer. Important Warnings Invisible Fence® Brand pet containment systems have contained over two million pets. However, there are some precautions you should take. Warning: Not every pet can be trained to avoid the established boundary. Sometimes even a properly trained pet may cross the boundary. Therefore, Invisible Fence®, Inc.
CAUTION: Modification or changes to this equipment not expressly approved by Radio Systems® may void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
www.invisiblefence.
800-578-DOGS (USA) (865) 777-5404 (International) 400-xxxx © 2008 Radio Systems Corporation® All rights reserved. 10 www.invisiblefence.