A-Tag Models T11-120 – Status & T21-120 – Non Status RTLS Tags Installation Instructions RadarFind™ Corporation 877-RadarFind (723-2734) www.radarfind.
12/5/2008 Radarfind Corporation A-Tag Installation Instructions Page 2 of 10 Warnings: It is important to follow all instructions shipped with this product. UNPACKING: After unpacking the unit, examine it for damage that may have occurred in transit. If the equipment has been damaged, do not attempt to install or operate it. File a claim immediately with the carrier stating the extent of the damage, or contact RadarFind customer service for repair or replacement.
12/5/2008 Radarfind Corporation A-Tag Installation Instructions Page 3 of 10 Contents of standard package: (1) T21-120 - A-Non status Tag Either or (1) - T11-120 – A-Status Tag (1) 80-100-1003 A-Tag Mounting Base (1) 80-000-1001 – Adhesive Pad Copyright © RadarFind Corp 2008
12/5/2008 Radarfind Corporation A-Tag Installation Instructions Page 4 of 10 Accessories A12-3T00 (2) Stainless steel mounting straps (for application of Radarfind tag mounting base (Part# TBA-3160) to tubular structures) Note: For best performance the steel straps require a special tool to tighten and cut the strap.
12/5/2008 Radarfind Corporation A-Tag Installation Instructions Page 5 of 10 General Guidelines: All tags on an asset type should be the same type, e.g. all infusion pumps should have an A-Status Type tag. Select a standard location on each asset type for the tag. For A-Status tags select a location where the status indicator is plainly visible and can be easily accessed by the user when switching the status switch.
12/5/2008 Radarfind Corporation A-Tag Installation Instructions Page 6 of 10 Using adhesive pad – Clean the area on the asset with alcohol to ensure a good bond. Remove white side of the adhesive covering and place on tag base, aligning the hole in the center of the adhesive over the base locking mechanism. Remove red backing and apply to asset.
12/5/2008 Radarfind Corporation A-Tag Installation Instructions Page 7 of 10 Auxiliary attachment: Use a standard plastic “Tie-Rap” to attach the tag base to permanently mounted cords or handles of assets where there is no convenient flat mounting spot. Use tie-rap to attach tag to oddly shaped assets Mounting to tubular fixtures: Use stainless steel straps to attach tag to tubes or poles.
12/5/2008 Radarfind Corporation A-Tag Installation Instructions Page 8 of 10 Installation Steps – Attaching tags with adhesive: Step # 1 - Select location for tag and clean area for adhesive with alcohol. Step # 2 - Attach adhesive to tag base with adhesive or straps. Step # 3 – (Assuming that you have already entered your assets - See next page for ADDING assets in the RadarFind database.) Select asset by entering the serial number or asset inventory number.
12/5/2008 Radarfind Corporation A-Tag Installation Instructions Page 9 of 10 Run-Time Asset Additions or Edits To edit a current asset locate the asset in the asset table and hit the edit icon. To add a new asset to the database select Add an Asset from the menu bar. Selecting either Edit or Add will bring you to the following asset edit screen where you can enter or edit details concerning the asset.
Radarfind Corporation A-Tag Installation Instructions 12/5/2008 Page 10 of 10 Technical Specifications: Models T11-120 – Status & T21-120 – Non Status RTLS Tags DC power: Power consumption: Communications Transmit Power Antenna: Communications: Operating: Packaging: Accessories: Internal sealed lithium battery Average 15uA 902-928 MHz FSK +8dBm maximum Unity gain isotropic FCC Subpart 15.