Installation Instructions Radarfind Corporation ™ A-Tag—Non-Status Model T10-B011 12/28/2006 Radarfind Corporation— Phone 877 Radarfind—www.radarfind.
Warnings: It is important to follow all instructions shipped with this product. Failure to follow all safety precautions and instructions may result in property damage, serious injury, or death to you or others. UNPACKING: After unpacking the unit, examine it for damage that may have occurred in transit. If the equipment has been damaged, do not attempt to install or operate it.
Contents of standard package: (1) - T10-B011 – A-Status Tag (1) TBA-3160 – Mounting Base (1) A12-1A0B – Adhesive Pad (2) A12-1T0B – Plastic mounting strap 12/28/2006 Radarfind Corporation— Phone 877 Radarfind—www.radarfind.
Accessories A12-3T00 (2) Stainless steel mounting straps (for application of Radarfind tag mounting base (Part# TBA-3160) to tubular structures) Note: For best performance the steel straps require a special tool to tighten and cut the strap. 12/28/2006 Radarfind Corporation— Phone 877 Radarfind—www.radarfind.
General Guidelines: All tags on an asset type should be the same type, e.g. all infusion pumps should have an A-Status Type tag. Select a standard location on each asset type for the tag. For A-Status tags select a location where the status indicator is plainly visible and can be easily accessed by the user when switching the status switch.
Using the supplied plastic strap: Use the supplied plastic “Tie-Rap” to attach the tag base to permanently mounted cords or handles of assets where there is no convenient flat mounting spot. Use tie-rap to attach tag to oddly shaped assets Mounting to tubular fixtures: Use stainless steel straps to attach tag to tubes or poles. For best results mounting to tubular fixtures, such as IV poles or wheelchair frames, the locking base is equipped with strapping holes.
Installation Steps – Attaching tags with adhesive: Step # 1 - Select location for tag and clean area for adhesive with alcohol. Step # 2 - Attach adhesive to tag base with adhesive or straps. Step # 3 – (Assuming that you have already entered your assets ) Select asset by entering the serial number or asset inventory number.
Technical Specifications: Tag (Model T10-B011) DC power: Power consumption: Communications: Transmit power: Antenna: Communications: Operating: Packaging: Accessories: Dimensions: 12/28/2006 Internal sealed lithium battery Average 15uA One 350 kHz FSK channel at 915 MHz -10dBm Unity gain isotropic FCC Subpart 15.249 5 to 35º C, 5% to 90% RH, non condensing ABS Plastic (UL Flammability Rating V0) Adhesive pad, holding base, plastic mounting straps, and steel mounting straps Optional holding base (2.
