Instructions / Assembly

H O M E S T O R A G E P R O D U C T S

WWW.RACORSTORAGESOLUTIONS.COM

Note: When choosing a location for your ladder make sure there is enough room to raise and lower the ladder. All obstruc-

tions and people should be moved out of the way when raising or lowering.

WARNING

All ceiling mounted parts are to be ﬁxed to a ceiling joist only.

LADDER LIFT | LDL-1B

INSTRUCTIONS

Phillips driver

TOOLS REQUIRED

PARTS LIST

5/32” Drill bit

3/16” Drill bit

Drill

Tape Measure

x1 J-Hook

x1 Pulley/Rope/Strap

assembly

x1 Two-piece Pulley

assembly cover

x1 Rope cleat

x3 Lag screws

x4 Phillips screws

Mark the location for the J-hook on a ceiling joist.

The J-hook must be secured to the joist with 2 or 3

screws as shown. Pre-drill 3/16 in. pilot holes into

the ceiling joist and fasten the J-hook with provided

screws.

Lag screws

WARNING

Please read installation instructions carefully prior to installing. Before using the product thoroughly test the fully-weighted

product (with equipment in place) to ensure the product has been installed properly. Do not allow children to play on

product. ITW Brands is not responsible for any damage resulting from improper installation, overloading or product failure.

PAGE 1
HOME STORAGE PRODUCTS LADDER LIFT | LDL-1B INSTRUCTIONS WWW.RACORSTORAGESOLUTIONS.COM TOOLS REQUIRED PARTS LIST Phillips driver x1 J-Hook 5/32” Drill bit 3/16” Drill bit x1 Rope cleat x1 Pulley/Rope/Strap assembly x3 Lag screws Drill Tape Measure x1 Two-piece Pulley assembly cover x4 Phillips screws WARNING Please read installation instructions carefully prior to installing.
PAGE 2
Measure the distance between the outermost rungs on the ladder to mark the two hanging points. Mark the distance on your ceiling from the center of the J-hook to the center of pulley assembly. If there is no joist at this location, mount the pulley assembly on the next closest joist away from J-hook, NOT towards it. Alternately, mount a 2x4 spacer board to two joists and mount the pulley assembly to this board to help place the pulley assembly above the outermost rung.
PAGE 3
1 3 2 A RAISING THE LADDER 1. For an extension ladder, lift the top of the ladder and place the top rung on the J-hook leaving the bottom of the ladder on the floor. For a platform ladder, place the top of the platform on the J-hook. 2. Wrap the strap around the bottom rung of the ladder. Secure the strap by inserting the metal curved tab into the corresponding metal slot. 3. Begin raising the ladder by pulling down on the rope.