3 SM ART SPRINKLER CONTROLLER Let’s get started.
What’s in the box.
What you’ll need. Wi-Fi Access (2.4 or 5 GHz) Phillips Screwdriver Smartphone or Tablet Hammer (Drywall Installs) Drill and Drill Bit (Drywall Installs) The Rachio 3 Sprinkler Controller is designed for indoor installation. If outdoor installation is required, you’ll need our weather-resistant enclosure. Learn more at rachio.com/outdoors.
Need some help? Check out our Help Center Give us a call. support.rachio.com 1 (833) 722 4463 Not sure what to do with your old controller? We’ll recycle it for free! Visit rachio.com/recycle.
STEP 1 Out with the old! Test your old system to ensure everything works properly. Photograph the wiring inside your existing controller to reference during installation. Remove your old controller from the wall.
STEP 2 Mark screw locations. Use the Mounting Template at the end of this guide to mark where you want to install your Rachio 3. For Drywall Installation: Drill holes at marked locations for the anchors. Use a 3/16 inch bit to drill through the drywall, then use a hammer to gently tap each anchor into place.
STEP 3 In with the new! Remove the Rachio 3’s magnetic faceplate. Mount your new controller by screwing it onto the wall using the provided screws.
Mounting Template Ensure the lower holes are level, and use a pencil to mark the center of each hole.
Tear here to detach the mounting template.
STEP 4 Connect your wires. While referencing the photo of your previous wiring, insert the wires into the appropriate terminals. Things not matching up? Visit rachio.com/wiring for tips on advanced wiring. C 1-16 Common Wires Zone Wires Common wires are often labeled “C” or “Com.” You can insert them into any of the white “C” terminals. Zone wires correspond to your landscape’s zones. Insert them into the blue, numbered terminals.
M S1-2 24 VAC Master Valve Sensor Wires (Optional) Not all systems have a master valve. Master valve wires are often labeled “M,” “MV,” or “Pump.” If you have a master valve, wire it into the dark gray “M” terminal. You are able to connect up to two rain or flow sensors to your controller using the “S1,” “S2,” and 24VAC sensor power terminals. For more information, visit rachio.com/sensors. Insert the power connector upward into the power jack located at the bottom right of the wiring bay.
STEP 5 Create an account. Find the Rachio app on the Apple App Store, on Google Play or by visiting rachio.com/download. Once the app is installed, create your account.
STEP 6 Connect to Wi-Fi. Open the Rachio app and select “Add Controller.” The app will guide you through this process. Once your controller is online, the light bar will pulse blue. You can now replace the magnetic faceplate.
STEP 7 Complete setup on the app. Now that the controller is online, use the Rachio app to customize your zones and create a schedule.
Congrats, you did it! Want to learn more about what you can do with your new Rachio 3? Control your system remotely. Integrate your smart home. Optimize your waterings. Visit rachio.com/more.
Manual Controls Zones can be run directly from the controller, if needed. Use the forward and back buttons to select a zone on the light bar, then select play.