Gotcha! Owner's Manual GT500R Series Important! TEST PERIOD LASTS FOR 5 MINUTES AFTER POWER IS TURNED ON. HM The Gotcha has a 5 minute test period to allow a walk test during daylight. During this five minute period the unit will turn lights on for only 4-5 seconds after motion ceases. W After the 5 minute test period, the Gotcha will reset itself to night only operation. WM For an additional 5 minute test period, turn power off for 5 seconds, then back on.
Selecting A Location How large an area wil Golgotha protect? When mounted al the recommended height feet, the detection pattern extends ott 40 60 feet and is 110° wie. To reduce coverage: aim the sensor towards the ground.
Assembly and Wiring Caution: TURN OFF ALL POWER BY REMOVING POWER FUSE OR TURNING OFF CIRCUIT BREAKER. WW Read entire Owner's Manual before proceeding WR Alf wiring should comply with local electrical codes and may require a qualified electrician. WW The total lighting load connected to the Gotcha must not exceed 500 watts transcendentalist or 250 watts fluorescent. To switch more wattage, an electrician can install a relay to handle the load. Do not use to control motors or high intensity discharge lights.
Helpful Aiming Hints Do Not Aim Chitchat: MW Above or douching its own fights. Heat from lights triggers sensor Ml Tilted from side to side. Part of protection pattern unusable Move sensor below lights Careers Position sensor exactly level from side fo side Corrie: W Where reflections come from shiny or light colored objects such as cars, windows or white walls.
Troubleshooting Each Gotcha undergoes rigorous testing and quality control procedures before il leaves the factory. Malfunctions are most often due to incorrect installation or aiming of the unit. Lights Do Not Turn On 1. Tum off power for at least 5 seconds, then on again. Remember the daylight fest period is only 5 minutes long. 2. Check that bulb and fixtures work. Compare wiring to the wiring diagram. Check halt power is on. 3.