Installation Manual

GOOSENECK LED INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting xtures. Our goal is to design the best quality products to get the job done right. We’d
like to hear your comments. Call the Marketing Department at 888-RAB-1000 or email: [e-mail]
Easy Installation & Product Help
Tech Help Line
Call our experts 888 RAB-1000
©2012 RAB LIGHTING Inc.
Northvale, New Jersey 07647 USA
rabweb.com
Visit our website for product info
email
Answered promptly [e-mail]
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
RAB xtures must be wired in accordance with the National Electrical Code and all applicable local codes.
Proper grounding is required for safety.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE
APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE
PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining xture. No user serviceable
parts inside.
1
1. Thread the Bushing onto the Arm.
2. Feed leads through the Arm. Slide the
Silicone Sleeve on the Arm.
3. Mount Housing to Bushing with three
set screws. Check that Bushing Gasket
is seated properly.
4. Tighten all Set Screws.
5. Loosen Swivel Screw and adjust
xture to desired angle. Tighten
Swivel Screw.
6. To ensure weatherproof seal USE
TEFLON TAPE ON ARM THREADS or use
weatherproof silicone sealant between
Arm and Bushing. In addition, after
installing the Arm, PULL DOWN THE
SILICONE SLEEVE TO COVER THE ARM
THREADS.
Housing Mounting
Bushing
Arm
Housing
Swivel
Screw
Set Screws (6)
1. Insert arm into Wall Plate. Tighten Set Screws.
2. Make supply wiring connections in recessed box
with UL approved connectors.
3. A universal voltage driver permits
operation at 120V to 277V, 50 or 60Hz.
4. Mount Wall Plate to the wall with
hardware appropriate for your
mounting surface.
5. To ensure weatherproof seal, apply weather-
proof silicone sealant around the edge of the
Wall Plate. This is especially important with an
uneven wall surface.
Arm Mounting to Wall and Wiring
(GOOSE1, GOOSE2 & GOOSE3)
Set Screws
Bushing
Gasket
Wall Plate
Optional
Photocell
1. The Shade mounts to the Housing with
four Shade Mounting Screws provided
with the Shade.
2. Shade has keyhole slots for easy
installation.
Angled Dome Shade
CAT# GSAD & GSAD11
1. Remove frosted lens & frame.
Install Spot or Rectangular
Reector.
2. When installing the Rectangular
Reector be aware of the direction
Rectangular Light Pattern.
See illustration below.
3. We recommend using a clear lens for
these reector types. Replace frosted
lens and frame with clear lens & frame
provided with this kit.
4. Tighten four Housing Screws.
5. Add shade if desired.
Lens Reector Kit
CAT# LRFGNLED, LRFGNLED26 Clear Lens with Spot Reector and Rectangular Reector
for optional patterns.
Shade Mounting
screws(4)
GSAD /GSAD11
Shade
Housing
Housing Screws (4)
Rectangular Reector
Rectangular Light Pattern
Orient reector properly within xture or
rotate xture to set beam in
orientation desired.
Spot Reector
Silicone
Sleeve
0913