User's Manual Part 2

iDEN Add-On Filter Box

User’s Manual -16-

3. Hardware Installation

The installation procedure is as follows:

 Check List of Items

 Mounting

 Grounding

 RF Connection

 Power up

3.1 Check List of Items

Index Items Q’ty

1 iDEN Add-On Filter Box 1

2 Power Cord 1

3 Screws for Mounting 4

Items

Figure 10. Items

PAGE 1
iDEN Add-On Filter Box 3. Hardware Installation The installation procedure is as follows: Check List of Items Mounting Grounding RF Connection Power up 3.1 Check List of Items Index 1 2 3 Items iDEN Add-On Filter Box Power Cord Screws for Mounting Q’ty 1 1 4 Items 1 Figure 10.
PAGE 2
iDEN Add-On Filter Box 3.2 Mounting iDEN Add-On Filter Box is easy to mount using the assembled mounting bracket, which has Ø9 holes for the provided 5/16" fixing screws. Figure 11. Mounting 3.3 Grounding WARNING Dangerously high voltages may occur and damage the equipment if the equipment is not grounded properly. A screw at the bottom is intended for a building ground. Connect the ground cable to the screw.
PAGE 3
iDEN Add-On Filter Box Figure 12. Grounding 3.4 RF Cable Connection a. Connect a cable from a donor antenna to the Input Port. b. Connect a cable from the Filtered Output Port to a repeater’s donor port Donor Antenna Service Antenna Mobile Service Donor Repeater Figure 13.