Content Product Features 1 Components Name + 2 Specification Parameter 3 Usage Instruction 4 Installation Instruction 5 Water level adjustment 13 Daily Maintenance & Usage Caution -15 Troubleshooting Guide r= 17 Issue Cause Resolution The solenoid valve inside the valve body is 1 | Water not shut off automatically opened Please operate flushing first time dus fo large shaking or by sensing once impact during transportation or installation.
Insert the water supply pipe back to the water connector and tum on the water supply valve. 3. Low voltage battery determination and replacement Sensor module is under voltage During the use of the product, wave to sense, the indicator light of the sensor module quick flashes 5 times, indicating that the battery is undercarriage and needs to be replaced.
(HOSE SETS @ FLUSH VALVE BODY @ BASE Battery box holder (Q Screw + expansion tube Mi | button {two shapes are optional) (D Sensor module (9 Control module If the product is updated, it will be compiled into the new manual without prior notice; the appearance, color and accessories of the product are different according to the actual needs; the factory does not supply the battery, you need to buy it yourself. Note: Two options of manual buttons: round shape and square shape. Usage Caution 1.
3.Remaining water level adjustment This product can adjust the remaining water level through the remote control. The higher the remote control adjusting level is the lower the water level will be. The product does not include remote control. If you need to adjust the water volume with the remote control, please contact the supplier. For details, please refer to the "Remote Control Instructions”. Working temperature 2C-45TC Working Dynamic pressure of 0.07Mpa Static Pressure pressure of 0.
Wave-sensing flush 1.Valve height adjustment Major Water level adjustment) Om «® A Press the buckle with one hand and pull or press the water inlet fixed cover at the same time. Mechanical push button flush ( If the battery is with low voltage or electronically faulty) Release the buckle when the water inlet cover is adjusted to the appropriate scale.
qQy £~ step @ Install sensor module batteries within three minutes after installing control module batteries, After installation, perform sensing once and finish the code matching. Note: When using more than one products, the code matching must be done one by one separately. Install the battery box holder on the water inlet connector; then install the control module into the battery box holder; and connect the control module with the DC connector on the valve body.
1. Installation of flush body and base Method B: Adhesive fixing B-1: Clean and dry the per-installation area of sensor module holder (when deciding the installation position, it should be | B-2: Tear off the double-sided adhesive sticker on the back of the sensor module holder and paste it vertically on the wall. Remove the base from the body @ Two piece base lockout ‘ Remove the lockout from the base. One piece base screwdriver V-type buckle Screw the V-type buckle to the end of the bolt.
The installation method of control module holder can be selected according to the installation wall. Method A: Screw fixing Suitable for installation on rough gray walls and other rough walls Method B: Adhesive fixing Suitable for installation on tiles and other smooth walls. A-2: Drill two holes with diameter 6mm in the vertical direction of the wall, the center distance between the two holes is about 50.5mm, and the depth is 30mm.
3. Push button installation a key-press plastic washer Key-press rubber washer key-press nut Remove the nut, plastic washer, rubber washer from the key-press body. y outside of the water tank into the tank; Install the rubber washer, plastic washer from the inside of the water tank onto the push button body and lock it with the nut. Press the buckle and load the button box into the push button sets. 4. Refill hose installation refill hose Inge rt the refill tube into the overflow pipe.