THE VALOR CEILING FAN INSTALLATION INSTRUCTIONS Please read and save these instructions These instructions are to be used in the installation of the following QUORUM INTERNATIONAL fans... The Valor © 2011 Quorum International. All Rights Reserved. P.O.
QUORUM'S UNIQUE LIMITED LIFETIME WARRANTY This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. WHAT IS COVEREDExcept as specified below, the manufacturer of this product warrants it to be free of all defects in workmanship and material. WHAT IS NOT COVERED BY THIS WARRANTY1. All costs of removal or reinstallation of the fan. 2. Damage resulting from failure to follow instructions contained herein. 3.
1. SAFETY RULES 1. To avoid possible electric shock, turn off the electricity at the main fuse box or circuit panel before you begin the fan installation or before servicing the fan or installing accessories. 2. Read all instructions and safety information carefully before installing your fan and save these instructions. 3. Make sure all electrical connections comply with local codes or ordinances as well as the National Electrical Code.
3. MOUNTING OPTIONS 1. Disconnect the power by removing fuses or turning off circuit breakers. 2. If there is an existing outlet box, ensure it is clearly marked "Suitable for Fan Support". If it is not so marked, it must be replaced with an approved one. WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, FIRE, OR PERSONAL INJURY, MOUNT THE FAN ONLY TO AN OUTLET MARKED ACCEPTABLE FOR FAN SUPPORT AND USE MOUNTING SCREWS PROVIDED WITH THE OUTLET BOX. Fig. 1 Fig. 2 Ceiling Joists Ceiling Joists 3.
4. HANGING YOUR FAN WARNING -Turn off the power! DO NOT fasten the blades to the fan until it is assembled and hanging from the ceiling. To do so now will likely bend the blade arms and almost certainly cause wobble. Fig. 5 Fig. 7 Downrod Hanger bracket CAUTION: Remove 4 rubber packing mounts from fan motor assembly and discard before installation. Ceiling canopy Canopy Screw 1. Remove the decorative canopy bottom cover from the canopy by turning the cover counter clockwise. (Fig. 5) 2.
5. ELECTRICAL CONNECTIONS REMEMBER -Turn off the power! 4. Inside the ceiling junction box be sure to spread the wires apart so that the black and blue connections are on one side of the outlet box and the white/white and green/ copper connections are on the other side. Fig. 9a Fig. 9b BLK GROUND BLUE GRN Fan/light switch on wall WH BLUE Outlet box WH GROUND GRN GROUND GRN WH WH WH BLK Fan switch on wall BLK BLK BLK Fig. 9 WH 2. (Fig.
6. COMPLETING THE INSTALLATION 1. Make sure the wiring is safely inside the Fig. 10 outlet box as instructed in Step 5 Electrical Connections. To install the canopy, slide the canopy up to hanger bracket and place the key hole on the Hanger canopy over the screw on the hanger bracket bracket, turn canopy until it locks in place at the narrow section of the key holes. (Fig.
7. FAN OPERATION AND CARE 1. A ceiling fan is an environmentally smart choice to cool as well as to help warm your home or office. Adjust your HVAC thermostat during fan use to save additional energy and money on your air conditioning and heating utility bills. You should see a significant reduction in both your heating and cooling costs by regular use of your fan. Do not hesitate to use your fan during summer and winter months. In summer, (Fig.
8. TROUBLESHOOTING FAN WILL NOT START 1. Check that the electricity has been turned on at the circuit breaker which had probably been turned off during installation. 2. Turn off the electricity. Check all connections in the wiring of the fan at the ceiling and make sure it follows the wiring instructions outlined in this manual. NOISE Note: Always allow a day or two "run-in" time for any new fan at medium or high speed.