User's Manual

ManualsBrandsQuirky ManualsElectronicsTripper

SZ-DWS04 ZigBee Door/Window Sensor Installation Guide

Specification

Frequency 2.4GHz

Batter Type CR2032 Battery

Sensitivity > 3 cm ( 1.18 inch )

Operating Temperature

0° C to 40° C (32° - 104°F)

Storage Temperature

-20° C to 60° C (-4° - 140°F)

Battery Life 3 years

RF Range 40M

Dimension

Main Unit: 51 mm x 26 mm x 7.4 mm (2" x 1.02" x 0.29")

Magnet Unit: 28.3 mm x 15.5 mm x 7.4 mm (1.11" x 0.61" x 0.29")

Package Contents

Tripper

Summary of content (6 pages)

PAGE 1
Tripper ZigBee Door/Window Sensor Installation Guide SZ-DWS04 Specification Frequency 2.4GHz Batter Type CR2032 Battery Sensitivity > 3 cm ( 1.18 inch ) Operating Temperature 0° C to 40° C (32° - 104°F) Storage Temperature -20° C to 60° C (-4° - 140°F) Battery Life 3 years RF Range 40M Dimension Main Unit: 51 mm x 26 mm x 7.4 mm (2" x 1.02" x 0.29") Magnet Unit: 28.3 mm x 15.5 mm x 7.4 mm (1.11" x 0.61" x 0.
PAGE 2
Intallation NOTE: Please make sure that the sensor and magnet is located less then 1.27cm (0.5 inch) from each other. Intallation 1. Hold the sensor near the top of the door, close to the opening edge of the door. This is the mounting location for the sensor. 2. Pull the exposed plastic pull tab from the sensor 3. Use either one of the following methods to install the sensor: • Remove the back plate of the sensor; use this as the mounting bracket.
PAGE 3
• Use provided adhesive on the sensor. Attach the sensor to the door. Press firmly and hold in place for a few seconds. Magnet Setup 1. Attach the magnet on the location next to the sensor by using either one of the following methods: • • 2. Remove the back plate of the magnet; use this as the mounting bracket. Use the screwdriver to secure the back plate to the wall with the screws provided. Use provided adhesive on the magnet. Attach the sensor to the door.
PAGE 4
Operation • • The LED will stay off during the normal operation. The sensor is equipped with a tamper switch. If the cover of sensor is removed, the sensor will send an alarm to the ZigBee coordinator. The sensor will be in "Awake" mode before replacing the cover. Reset to Factory Defaults A security sensor should be able to be manually defaulted from the device by putting it into a state where it is ready to be paired to a CPE.
PAGE 5
FCC Statement This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
PAGE 6
Ce dispositif est conforme à la norme CNR-210 d'Industrie Canada applicable aux appareils radio exempts de licence. Son fonctionnement est sujet aux deux conditions suivantes: (1) le dispositif ne doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris un brouillage susceptible de provoquer un fonctionnement indésirable. Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment.