Digital FM radio Turn on the Radio: Press side key PF1 (The default value of the radio key set is the radio mode.), the receiving light flickers green and it will search the radio station automatically. When it accomplishes the search and starts up the radio listening, the green light stops.
Battery capacity prompt There are 4 situations to estimate the battery capacity, when you re-start the transceiver, the green light for receiving flashes four times, it means the capacity is very full. the green light for receiving flashes three times, it means the capacity is full. the green light for receiving flashes two times, it means the capacity is not full. the green light for receiving flashes one times, it means the capacity is low.
CO: The transceiver stops scanning when detecting signal, and continues scanning 3 seconds after the signal disappears. Press PTT, it transmits the channel specified by encoder. After the transmission, it stops scanning. SE: The transceiver stops scanning when detecting signal. Press PTT, it transmits the scanned channel. If there are still no operations in 10 seconds after the transmission, it will be back to transmit the channel specified by encoder.
Receiving/Transmitting frequency programmable The receiving/transmitting frequencies can be programmable accordingly within the original frequency range. Low voltage prompt When the battery pack is on low voltage, the transceiver will sound voice programmable to remind of being charged timely. Wire clone function a. Installing battery packs on source radio and target | Transmitting red LED flashing means radio and connect them via wire clone cable. transmitting data when wire cloning. b.
f. Read from the radio to check the connection. g Setting on the software accordingly. h. Write to the radio. If you get the message "failed connection* when you try to read from the radio, please check the first five steps and the communication ports accordingly. Please note that once the first three steps are done well, the com port will be selected automatically when you open the software.
( Problem Solution h In standby, the transceiver transmits Check if the VOX function is on and its level setting is too low. automatically without pressing PTT key. Some functions Check if the transceiver work in channel mode. Some functions only can be cannot be memorized | memorized via programming software in channel mode. Receiving signals from other groups while Please change the CTCSS/DCS frequencies for all group members. \ communicating J 23 Technical parameter Appendix 1 CSS h 1 67.0 1" 94.
We endeavor to achieve the accuracy and completeness of this manual, but is still not perfect for any possible omission or printing errors. All the above specifications are subject to be revised without prior notice.