When firer bit of Exa byte in frequency displays indicates MDT function salable. 442 125 When first bit of Exa buts in frequency displays “T°. it indicates r 2 Tone function enable. i 44a 125 Wuhan first bit of Exa byte in frequency displays F ®#indicates 5 Tons function scabies. F 4 4a 125 This function can be temporarily used in channel mode. Once the radio is tumid off or switched to another channel, the temporary setting will be erased and back to initial settings.
Enables Frequency Reverse Disposable Frequency Ravers 3. Press number keys to confirm and exit NOTE: This function can be temporarily used in Channel mode . Once the radio I fumed off or switched to another channel, the temporary setting will be staged and back to initial sailings TOT (Time-out timer) The time-out timer limits the amount of transmitting time. When you reach the time limit which has bans programmed by your dealer, your transmission will be cut off.
BEEP-OF tum off voids prompt BEEP--ON tum on voice prompt 3. Press number key to exit and store. HIGH/MID/LOW Power Selection 1. In standby.press (mg) then press LCD displays POWWOW. 2. Press | [TED sadistic the desired power, Hi High Power Middle Power LOW Low Power 3. Press number keys to exit and stirs. LCD Back light 1. in standby status press (NSF, then press (B35) LCD displays LAMP. 2. Press | (TED / 2) 1io slacks desired back light levelness.
. When the alarm cable or is removed from the DATA jack of out by improper sequence, the alarm function annals and will alarm as programmed. In heartwarming transceiver wil stop alarm once receiving a matching signal. And alarm again wham a matching signal disappointing: &. Restart radio fo cancel anti-theft alarming Reconnect with alarm cable and tum off radio, the system will return to alarm mode. Cable Clone This feature will copy the programmer date and parameters in the master unit to slave units.
Programming Software Installing and Starting (in windows XP system) Double click "TYT TH-8000%, then follow the installing instruction. Install USB Cable Driver Programmer A. Click start menu in computer, under "ALL PROGRAMS" menu, choose and click "USB To Com port” in TH-8000 program, install "USE Te Com port™ driver by indication. 2. Connect the optional USB Programming table to USB port In PC with transceiver.
Maintenance Trouble Shooting ) . . Default Setting after Resoling(VHF) DOS encode and decode: Problem CLO a RIEL I encode Power Is on, nothing appears + and polarities of power connection are reversed. VFO frequency 145 00MHz DCS code 023N 9 Memory channel 0-199 Output r H on Display. Conn act red lead to plus terminal and black lead to restitution Cockeyed resting oF minus terminal of DC power supply. Offset SOK ToT oF (b) Fuse is blown. Check and solve problem resulting in blown fuse Channel step pry.
Attached Chart #1024 groups DCS Code. & 50 groups CSS Tone Frequency(Hz) 000 oo 002 003 004 005 008 007 670 [797 |948 [1109 [1318 [1567 | 171.3 | 186.