WIRELESS CHIME/PAGER FEATURES: Modern & Stylish design 5 levels of volume Easy installation IP55 Waterproof Approx.
RECEIVER
TRANSMITTER 1: Call Button TRANSMITTER 2: Push Button of Doorbell
TRANSMITTER 3: Door Sensor THE FIRST USE GUIDE: 1.Plug the receiver into a mains socket, and switch the socket on. 2. Press the transmitter push button and confirm that the transmitter indicator flashes, the doorbell receiver sounds "Ding-Ding" and the receiverindicator flashes. The doorbell is paired. The default ringtone is "Ding-Dong". Users can change the ringtone easily, just refer to the "CHANGINGTHE RINGIONE' steps.
the factory default settings (it means that the ringtone you have set and the transmitters you have added/paired will be cleared). INSTALLATION: 1. Plug the receiver into a mains socket and switch the socket on. 2.
Replace the battery. 2. The battery may be inserted the wrong way round (polarity reversed), Insert the battery correctly, but be aware the reverse polarity may damagethe unit. 3. Ensure that the doorbell receiver is switched on at the mains. 4. Check that neither the transmitter nor the receiver are near to possiblesources of electrical interference, such as a power adaptor, or other wireless devices. 5.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.