TO USER Thank you for purchasing the digits! / analog two way radios designed and produced by Lanzhou City New Century Communication Electronic Co., Lid. This product Is developed elaborately as a regular digits! handheld radio according fo EU standard and advanced international technology.
Compliance with RF Exposure Standards ‘The radio complies with the following RF energy exposure standards and guidelines: © United States Federal Communications Commission, Horde of Federal Regulations; 47 CFR & 1.1307, 1.1310 and 2.1083 » American National Standards Institute (ANS / Institute of Electrical and Electronic Engineers (IEEE) C25. 1:2005; Canada RESPIRE issue b March 2016.
Safely: & if important that the operation is aware of and understand the general hazards io the operation of any caravansary. « Wa can't guaranties the safety and penetrability of transceiver that using other accessories not sold by us. 4 Disassembled and maintained by qualified technicians only. Warning: Tum off the transceiver in the following locations: * In explosive atmospheres. (inflammable gas.dust particles, metallic powders, grain powers, sic.
CONTENT (1) PREPARATION FOR OPERATING THE RADIO Pl save adverbials your radio by following sips The battery peck is not charged st the factory, charge i firstly bafflers use. installing the battery to the radio. installing the antenna, installing the belt clip... installing the conman interface fender (Dust Switch the radio power ON.
PREPARATION FOR OPERATING THE RADIO CHARGING THE BATTERY PACK Please uze charger, adapter and battery pack supplied only by us. The charger can indicate the charging status. Charging diagram: °y charging steps: 1. Plug the AC depilatory inch an AC outlet, lke row © 2. Plug the AC adapter cabs into the adapter jack located on the back of the charger, like amow® 3. Place the battery pack or the roadie with a battery pack into the charger, like amow® 4, The indicator lights rad and charging stars. 5.
PREPARATION FOR OPERATING THE RADIO Ney To remove the battery, tum off the mic firstly. Then slide the battery latch upwards fo unlock the battery, like diagram @. INSTALLING THE ANTENNA Tum off the roadie, holding the base of antenna, and then foreword i info the connector on the top of transceiver and tum clockwise until secure. To remove the antenna, tum off the radio firstly, and rotate it anticlockwise.
PREPARATION FOR OPERATING THE RADIO TURNING THE RADIO ON ADJUSTING THE VOLUME Short press the power switch for 3 seconds, you will here the Rosie clockwise the volume control io increase the volume pan phone or vies prompt. Than releases tha button, the radii after power on. has clumsy on, Rotate anticlockwise the volume control to decrease the volume. Note: 1. if the alert or voice prompt function is disabled, the radio will not have open tone.
CONTENT (1) KNOWING MORE ABOUT THE RADIO CONTROLS SETTING Please review the following sub-directory fret: Radio controls. Programmable keys... Radios functions can be preset by programmable keys. Other sittings and liability functions can bs per-set by programmable PTT Switching beeves Analog and digital mods... LED indicator...
RADIO CONTROLS INTRODUCTION RADIO CONTROLS 2 Retribution like are programmable Key.
RADIO CONTROLS INTRODUCTION PROGRAMMABLE KEYS You dealers can per-set the programmable keys based on the length of a button press. P re-ssfting can be shortcuts of radio functions.
RADIO CONTROLS INTRODUCTION 4 information Check — Switch te check current channel and battery strength status information 4 Digital / Analog Mode — Switch between Digital Mode and Analog Mode. & SQ Level i — Select the proper SQ level to get the best signal in different environments. 4 P18 — Call Shortcut, press it io send corresponding call function. { Available only in radios without LCD display } 4 P2#8 — Call Shortest, press It fo send corresponding call function.
10 RADIO CONTROLS INTRODUCTION SWITCHING BETWEEN DIGITAL AND ANALOG MODE For your convenience, each channel can be programmed as either analog channel or digital channel. + In standby mode, pros | Digital / Analog | button for at least 3 seconds, the current channel will be switched western Analog and Digital mode. Note: During scanning, the radio also can stochastic between Analog and Digital mods, but scanning mode will be disabled.
CONTENT (111) INITIATING AND RECEIVING CALLS After you understand hove your radio bs configured, you ars able to use B mots dally, Use this directory fo familiar with the bask call feature: Chose a Zone, Choose a Shanna, User 13, Group ID. Receive and Answer a Call. Abrasive and Answer a Group Call... Receive and answer a Private Receive a General Call... Initiator o Racks Call. Use the Encoder Switch to Initial a initiate 2 Group Initiate a Private Call, Initiate @ General Call...