Installation Instructions

ManualsBrandsQuantus ManualsIndoor LightingBelle 1-Light Bronze Track Lighting Pendant

INSTRUCTIONS

FOR ITEM: 349-6712 (Track is sold separately)

UANTUS

1. Attach the glass shade to the glass

holder, secure it with socket ring.

2. Install a bulb (not included). See

relamping label at socket area or

packaging for maximum allowed

wattage.

Note: Follow enclosed “ To shorten

the cable of the pendant Instruction”

to adjust the length of the cable if

necessary.

WARNIGN: To avoid the risk of injury, be sure to turn off electrical power

while installing or servicing this fixture.

Adapter

Cable

Track

1-2 To mount Track,

drill holes in ceiling or wall.

Attach Track with toggle bolts

or screws if surface is solid material.

MOUNTING ADAPTER

TRACK

POLARITY LINE

Track

mounting

holes

Plain underside

of Track faces

ceiling or wall

Open,slotted side

of Track faces OUT

to accept lights

Dead end

fitting with

set screw

CAUTION: Turn off switch at main power source (fuse box)

before installing any Track or fittings.

STEP 1. Place Track over outlet box and mark position of

Track mounting holes on ceiling or wall. On wallboard or

plaster, drill 5/8" mounting holes and install Track to ceiling

or wall using toggle bolts. On wood surfaces, use standard

#10 wood screws.

STEP 2. Install mounting adapter and power fittings.

STEP 3. Switch on main power.

CAUTION: Disconnect power before installation.

To attach mounting adapter to the Track, align the polarity

lines of the Track and the polarity lines of the mounting

adapter. Push top portion of the adapter with contact

fingers into the slot in the Track and turn 90 (if the adapter

does not turn easily, do not force, but turn in other

direction.) To remove, depress the release lever with the

index finger and turn 90 .

MOUNTING ADAPTER INSTALLATION

ASSEMBLY INSTRUCTIONS

For Track Mounting:

Socket Ring

Glass Shade

Bulb Type A Max.100W

(not included)

Summary of content (3 pages)

PAGE 1
INSTRUCTIONS FOR ITEM: 349-6712 (Track is sold separately) WARNIGN: To avoid the risk of injury, be sure to turn off electrical power while installing or servicing this fixture. ASSEMBLY INSTRUCTIONS Track Adapter Cable Glass Shade Glass Shade Socket Ring Bulb Type A Max.100W (not included) CAUTION: Turn off switch at main power source (fuse box) before installing any Track or fittings. STEP 1. Place Track over outlet box and mark position of Track mounting holes on ceiling or wall.
PAGE 2
Figure.1 Outlet Box D(3/8") Wire Nut C(3") Adapter b B(9") a Screw c Mounting Strap Lock Nut Strain Relief Mounting Screw Canopy Cable Bolt Nut A Figure.2 For Ceiling Mounting: Cable 1. Cut off the cable near the bottom of the adapter. (See Figure 1) Cap Nut 2. Thread the cable through the canopy and two holes of the strain relief. Glass Holder 3.
PAGE 3
INSTRUCTIONS To Shorten the Cable of the Pendant (If in doubt, consult a qualified electrician) FOR ITEM: 349-6707 / 6708 / 6709 / 6710 / 6711 / 6712 WARNING: To avoid the risk of injury, be sure to turn off electrical power at the fuse box while installing or servicing this fixture. 1. Remove the adapter cover from the adapter holder by loosening the set screws (1). Remove the slide pad and spring, and set them aside. Set Screw Adapter Cover 3. Adjust the length of the cable: a.