User's Manual

1 Introduction

The Co-Pilot can control the exposure of three Remote Groups (R1, R2, and

R3) or two Remote Groups (R1, R2) and a local Qflash T5d-R.

A Remote Group can consist of :

Quantum Trio

and / or

Qflash T5d-R with an FW8R or FW7Q receiver

and / or

Any non Quantum flash that can be triggered by a sync signal, with

an FW8R or FW7Q.

Any number of remotes may be combined in a Remote Group, for the same

mode / exposure.

To separately set exposures of remote flashes, set them, to different Remote

Groups.

Qflash

Co-Pilot

QF91

Shoe Mount Wireless Radio

Commander for Qflash 5d-R

and TRIO

Operating Instructions

CHAN

OFF

Ratio / Manual Power

setting control for

Remote R1, R2, R3

MAN – TTL

Mode switch for

Remote R1, R2, R3

Channel select

switch 0 - 7

USB connector

ACCY connector for

Qflash T5d-R

ON / OFF switch

AF – Auto Focus

light is ON

R1 R2 R3 / LOCAL

M TTL M TTL M TTL

PAGE 1
MAN – TTL Mode switch for Remote R1, R2, R3 Ratio / Manual Power setting control for Remote R1, R2, R3 ACCY connector for Qflash T5d-R ON / OFF switch AF – Auto Focus light is ON M ON AF TTL R1 OFF M TTL R2 M TTL R3 / LOCAL CHAN Qflash® Co-Pilot QF91 Channel select switch 0 - 7 USB connector Shoe Mount Wireless Radio Commander for Qflash 5d-R and TRIO Operating Instructions To separately set exposures of remote flashes, set them, to different Remote Groups.
PAGE 2
ISO TTL M TTL R2 M TTL R3 / LOCAL Note : When using a non Quantum flash as a Remote Group set the MODE switch to M. MODE switch – this control sets the mode of the Remote Group to M (manual) or TTL. If the Remote Group is a Quantum Trio or Qflash T5d-R M R1 RATIO / MANUAL POWER SETTINGS – this control adjusts the exposure of the Remote Group. Ratio settings can be set from -27 to +2. Manual power settings can be set from 1/16- to 1/1. This control also has an OFF position.
PAGE 3
IMPORTANT – CAUTION Changes or modifications to this equipment could void your authority to use this product under the equipment authorization granted by the regulating agencies Pxxxx -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help.