COMPANY CONFIDENTIAL US106 Marketing Requirements Specification April 17, 2008 Revision Log: ހҁ (Version) Вය(Date) բ(ޣAuthor) অु(Modification Comment) 0.1 2008/4/16 Jack Ong Initial Release 0.2 2008/4/17 Jack Ong Specification updated ! 1 R0.
COMPANY CONFIDENTIAL 1. INTRODUCTION ..................................................................................................................................................4 1.1 1.2 2. SPECIFICATION .................................................................................................................................................5 2.1 2.2 3. SCOPE .....................................................................................................................................
COMPANY CONFIDENTIAL Definitions QOS WPA DPF Quality of Service Wi-Fi Protected Access Digital Photo Frame 3 R0.
COMPANY CONFIDENTIAL 1. Introduction This documentation describes the marketing requirement specification of the USB module. It is a confidential document of QMI. 1.1 Scope US106-AR module supports USB interface. US106-AR module is the perfect way to offer high-speed, worldwide wireless connectivity in DPF or others. 1.2 Target BOM cost USD 6 4 R0.
COMPANY CONFIDENTIAL 2. Specification 2.1 Hardware Specification Standard Compliance Physical Interface 2.2 IEEE 802.11b CCK modulation in the 2.4-GHz band IEEE 802.11g OFDM modulation in the 2.4-GHz band USB1.0/2.0 Software Specification Specification OS : Interface : Qos : Security : Windows XP/Vista, Linux USB1.0/2.0 WME, 802.11e WEP(64 and 128b), WPA 5 R0.
COMPANY CONFIDENTIAL 3. Product Requirements 3.1 Hardware Requirements Interface Network Standard Modulation Technique Operating Frequency Operating Channels RF Output Power Antenna Receiver Sensitivity Power Consumption USB IEEE802.11b/g 802.11b---- CCK (11Mbps, 5.5Mbps), QPSK (2Mbps), BPSK 802.11g----OFDM Direct Sequence Spread Spectrum 2.412 ~ 2.462 GHz: North America 2.412 ~ 2.472 GHz: Europe ETSI and 2.412 ~ 2.472 GHz: Japan (ARIB STD-33) 1~11 for N.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
ʳ End Product Labelingʳ ʳ This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: “Contains FCC ID:T5U-US106”.